Kenmore Dishwasher 363.1414691 (3631414691, 363 1414691) Parts
Genuine Ge part
By: Ge
Part Number: WD12X417
Protective cover that sits over your dishwasher's pump inlet to screen debris. Replace if cracked, broken, or missing to protect internal components.
Do-It-Yourself Stories from Customers like You
1 not draining properly 2 not cleaning properly 3 not filling properly 4 not running properly 5 sump and sump cap was filthy 6 James W. • San Diego , CA • March 19, 2017
1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve.
Parts $220 for Dishwasher
Estimated Labor $400.00
Labor $0.00
Parts $100.00 for Pullout Faucet
Estimated Labor $175.00
Labor $0.00
Read more
More
Genuine Ge part
By: Ge
Part Number: WH1X2036
Secures washer hoses at pump, tub, and valve connections to prevent leaks and hose blow-offs. Replace worn or missing clamps for a tight seal. Confirm fit.
Do-It-Yourself Stories from Customers like You
Drain hose was leaking Haide H. • Chatham Township , NJ • May 01, 2017
The video was very helpful. the hardest part is getting off old rusted parts. I had to use a hacksaw to remove one of the old clamps. I had to open the bottom of the washing machine to remove of the other clamp. Putting the new parts on was easy. Getting everything apart was a challenge. Putting the new parts on was an easy 5 minute job.
Read more
More
$15.95
- Compare At:
-
$18.98
- You Save:
-
$3.03
Genuine Ge part
By: Ge
Part Number: WD12X324
Detergent cup not opening during wash cycle? This actuator lever connects the timer to the dispenser lid. Moderate DIY repair, about 35 minutes.
This part fixes the following symptoms
-
Will not dispense detergent
See more...
Do-It-Yourself Stories from Customers like You
Defective timer John K. • Bear , DE • October 20, 2016
The timer was replaced. It took about 35 minutes. The most difficult thing was holding the door down.
Read more
More
Genuine Ge part
By: Ge
Part Number: WD12X334
Fix dishwasher overflows or underfilling with a new water level float. This part regulates filling by rising with water to signal the switch.
Do-It-Yourself Stories from Customers like You
1 not draining properly 2 not cleaning properly 3 not filling properly 4 not running properly 5 sump and sump cap was filthy 6 James W. • San Diego , CA • March 19, 2017
1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve.
Parts $220 for Dishwasher
Estimated Labor $400.00
Labor $0.00
Parts $100.00 for Pullout Faucet
Estimated Labor $175.00
Labor $0.00
Read more
More
$12.49
- Compare At:
-
$14.99
- You Save:
-
$2.50
Genuine Ge part
By: Ge
Part Number: WD1X1392
Secures dishwasher sump to tub, maintaining seal compression to prevent leaks. Replace if corroded or weak. Confirm fit with your model number.
Do-It-Yourself Stories from Customers like You
Leaking pump connector. David M. • Ypsilanti , MI • October 13, 2018
Took the impeller out, removed the pump, replaced connector, put new clamps on, reassembled and checked for leaks. I just followed Arts video, went smooth. Wifes happy, things are good.
Thanks AppliancePartsPros.com
Read more
More
$13.95
- Compare At:
-
$16.60
- You Save:
-
$2.65
Genuine Ge part
By: Ge
Part Number: WD21X479
Dishwasher overflowing or not filling? This float switch detects water levels to prevent overflow and control filling. DIY-friendly repair part.
Do-It-Yourself Stories from Customers like You
The dish washer was not fill with water Stanley B. • Newberry Springs , CA • December 14, 2014
1. Removed the water inlet/shut off valve, removed and cleaned the screen. while the valve was removed applied electrical power to the valve and it worked just fine.
2. replaced the broken float switch.
Read more
More
$71.95
- Compare At:
-
$85.58
- You Save:
-
$13.63
Genuine Ge part
By: Ge
Part Number: WD3X721
Replaces worn or broken pump solenoid springs in your dishwasher. Restore smooth operation when original springs are damaged, missing, or weakened.
More
$57.22
- Compare At:
-
$68.09
- You Save:
-
$10.87
Genuine Ge part
By: Ge
Part Number: WD12X10026
Replacement door vent directs humid air out during the dry cycle. Install inside the door panel to replace a cracked, clogged, or missing vent.
Do-It-Yourself Stories from Customers like You
Worn out tired dishwasher with some broken parts Laura C. • Black Canyon City , AZ • January 03, 2017
Found AppliancePartsPros.com and looked up parts and ordered replacement parts. ( VERY easy!) Replaced the spray arm assembly and door vent via the handy Q&A repair section, as well as a thorough cleaning, and VOILA! Clean dishes again!! Thanks for making it easy!
Read more
More
$14.39
- Compare At:
-
$17.12
- You Save:
-
$2.73
Genuine Ge part
By: Ge
Part Number: WD1X1363
Metal contact leaf for dishwasher switch assemblies. Replace if the original contact is bent, corroded, worn, or missing to restore proper circuit closure.
More
$18.95
- Compare At:
-
$32.08
- You Save:
-
$13.13
Genuine Ge part
By: Ge
Part Number: WD2X425
Secures the soap dispenser lever assembly in your dishwasher. Replace if screw is missing, stripped, or damaged during dispenser repair or maintenance.
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Genuine Ge part
By: Ge
Part Number: WD12X335
Guides the dishwasher float and connects it to the switch mechanism. Replace if cracked, broken, or worn to restore proper water level control.
Do-It-Yourself Stories from Customers like You
1 not draining properly 2 not cleaning properly 3 not filling properly 4 not running properly 5 sump and sump cap was filthy 6 James W. • San Diego , CA • March 19, 2017
1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve.
Parts $220 for Dishwasher
Estimated Labor $400.00
Labor $0.00
Parts $100.00 for Pullout Faucet
Estimated Labor $175.00
Labor $0.00
Read more
More
$26.74
- Compare At:
-
$30.68
- You Save:
-
$3.94
Genuine Ge part
By: Ge
Part Number: WD12X418
Fix dishwasher leaks or poor cleaning with a new sump cap. Seals the sump opening to contain wash water and protect the pump. Quick DIY replacement.
Do-It-Yourself Stories from Customers like You
1 not draining properly 2 not cleaning properly 3 not filling properly 4 not running properly 5 sump and sump cap was filthy 6 James W. • San Diego , CA • March 19, 2017
1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve.
Parts $220 for Dishwasher
Estimated Labor $400.00
Labor $0.00
Parts $100.00 for Pullout Faucet
Estimated Labor $175.00
Labor $0.00
Read more
More
$24.95
- Compare At:
-
$29.69
- You Save:
-
$4.74
Genuine Ge part
By: Ge
Part Number: WD2X295
Replacement mounting screw for dishwashers. Secures panels, brackets, or components inside the unit. Needed when original screws are stripped or missing.
More
$6.72
- Compare At:
-
$8.36
- You Save:
-
$1.64
Genuine Ge part
By: Ge
Part Number: WD35X200
Secures dishwasher cabinet to chassis for improved stability. Replace if original brackets are broken, missing, or causing movement and panel gaps.
Do-It-Yourself Stories from Customers like You
The whirlpool refrigerator kept leaking water into the icemaker and it would freeze everything Anthony W. • Lancaster , CA • December 07, 2015
I changed the water valve assembly and we have not had a problem since.
Read more
More
$57.59
- Compare At:
-
$69.11
- You Save:
-
$11.52
Genuine Ge part
By: Ge
Part Number: WD3X487D
C-clip retainers secure components in your dishwasher or range. Replace when clips are loose, broken, or missing to prevent rattling and parts shifting. Verify fit with your model number.
More
$35.95
- Compare At:
-
$57.56
- You Save:
-
$21.61
Genuine Ge part
By: Ge
Part Number: WD12X448
Covers the electrical junction box where the power cord enters your dishwasher. Replace if cracked, broken, or missing to protect wiring connections.
Do-It-Yourself Stories from Customers like You
Missing electrical cover and cord, Bruce S. • Egg Harbor Township , NJ • August 01, 2020
Used your parts. Worked great.
Read more
More
$12.95
- Compare At:
-
$15.41
- You Save:
-
$2.46