Kenmore Dishwasher 363.1556992 (3631556992, 363 1556992) Parts

This timer cover is the replacement trim that surrounds and protects the dryer or washer control timer on the control panel, restoring a finished look and shielding the timer mechanism from dust and debris. What it does:

• Replaces a cracked, faded, or damaged timer trim to improve appearance and protect the underlying timer assembly
• Helps keep lint, dust, and moisture away from the timer control area
• Restores correct alignment and mounting for the timer knob and control components
• Useful when the existing cover is loose, broken, or missing

• One timer cover

• Disconnect power (unplug or switch off breaker) before starting any repair
• Remove the control panel or access bezel per your model's service instructions to reach the timer cover
• Use appropriate hand tools (screwdriver) and avoid forcing plastic tabs to prevent breakage

This shield is a protective heat shield that helps protect internal components from heat and debris, extending appliance life and preventing premature damage. It's a direct-fit replacement for the damaged or missing shield. What it does:

• Protects wiring, insulation and nearby parts from excessive heat
• Prevents debris and grease from contacting sensitive components
• Helps stop heat-related odors or smoke caused by contact with hot surfaces
• Reduces risk of component failure due to heat exposure

• One protective shield

• Disconnect power (unplug or switch off circuit breaker) before starting any repair
• Allow appliance to cool completely to avoid burns
• Handle carefully—edges may be sharp; use gloves and proper tools
• Follow OEM disassembly steps and torque recommendations;

2 wire insulator.

This is a replacement fastener screw used to secure panels and components on compatible appliances, restoring proper fit and reducing movement. It's a simple, direct replacement when an original screw is missing or damaged. What it does:

• Secures access panels, covers, or internal components to prevent rattling and movement
• Helps maintain proper alignment of parts so doors and panels close correctly
• Replaces missing, stripped, or broken screws that can cause loose parts or noise
• Restores the appliance's original fit where a matching OEM fastener is required

• One replacement screw

• Turn off and unplug the appliance before starting any repair
• Use the correct driver and avoid over-tightening to prevent stripping threads
• If the original screw was holding electrical components, ensure power is disconnected and follow OEM safety instructions

Black. 8-18 x 5/16 inch.

This E-ring is a small retaining clip that secures shafts, spindles, and components to prevent lateral movement and keep assemblies in place. It restores proper alignment and helps stop parts from slipping off their shafts. What it does:

• Secures shafts and spindles by fitting into a groove to lock components in place
• Prevents lateral movement and component disengagement during operation
• Helps stop rattling or misalignment caused by loose parts
• Small, simple part used where a snap-in retaining clip is required

• Disconnect power before servicing and follow all safety guidelines
• Use snap-ring/needle-nose pliers or appropriate tools to install/remove carefully
• Ensure the ring seats fully in the groove and that the mating parts are correctly positioned
• Inspect mating shaft and groove for wear; replace if damaged

This kit is used to repair a leaking pump on GE made dishwashers. For a complete pump/motor assembly get WD26X10013.