Kenmore Washer 417.40052990 (41740052990, 417 40052990) Parts

This replacement top-panel bushing cushions and centers the oven's top panel to reduce noise, wear, and misalignment for a secure fit and smoother operation. It helps restore proper panel seating and reduces rattles or vibration. What it does:

• Positions and supports the top panel where it meets the cabinet
• Dampens vibration to help eliminate rattling or buzzing noises
• Prevents direct metal-on-metal contact that can cause wear or scratching
• Helps maintain correct panel alignment for a flush appearance

• Disconnect power to the appliance before beginning any work.
• Remove the top panel fasteners and lift the panel carefully; sharp edges may be exposed.
• Press the bushing into the panel or support hole until fully seated; confirm alignment before reattaching the panel.
• If the bushing is brittle or deformed, replace it to ensure secure fit and noise control.

This replacement overflow shield directs excess water away from sensitive components to help prevent leaks and water damage in the appliance. It restores proper drainage protection when the original shield is cracked, warped, or missing. What it does:

• Channels overflow or stray water away from critical areas to reduce risk of leaks
• Replaces damaged, cracked, or missing overflow shielding
• Helps maintain proper drainage pathways and component protection
• Commonly used when you see water pooling or dripping near the shielded area

• One overflow shield

• Inspect surrounding seals and fasteners; replace any that are damaged before installing the new shield
• Installation typically requires basic hand tools; secure the shield in the original mounting points
• Disconnect power to the appliance before starting work and restore power only after reassembly

This console support bracket secures the range or oven control panel, keeping the console aligned and stable for reliable button and knob operation. It restores proper panel fit and reduces movement or rattling during use. What it does:

• Provides structural support for the appliance control console or control panel
• Keeps the console aligned so switches, buttons, and knobs operate smoothly
• Helps stop console sagging, looseness, vibration, or rattling during operation
• Prevents stress on wiring and switches by holding the panel in place

• Disconnect power to the appliance before beginning any repairs; for gas ranges, shut off the gas supply.
• Support the console or control panel while removing fasteners to avoid dropping the panel.
• Use the original mounting screws and fasteners; align the bracket before tightening.