Kenmore Washer 417.40142000 (41740142000, 417 40142000) Parts

This dispenser drawer handle trim assembly replaces the trim and handle piece on the refrigerator dispenser drawer for a clean, finished look and reliable grip. It restores proper drawer operation and user access to the dispenser area. What it does:

• Replaces damaged, cracked, or worn dispenser drawer trim and handle for improved appearance
• Provides a secure grip to open and close the dispenser drawer smoothly
• Helps keep the dispenser opening sealed and aligned for normal drawer function
• Addresses visible cosmetic damage and loose or broken handle symptoms

• High-level replacement; typically requires removing the drawer or access panel—refer to your model's service diagram
• Disconnect power to the appliance before starting work to avoid injury
• Handle parts may snap or screw into place; save any retaining clips or screws from the old part for reuse

This 8-18 x 2.000 screw secures appliance panels and components, providing a reliable fastener replacement for restoring proper fit and reducing rattles or loose parts. Use where the original long 8-18 screw is required. What it does:

• Fastens appliance panels, brackets, or components where an 8-18 x 2.000 screw is specified
• Restores secure mounting to stop panel movement, rattling, or misalignment
• Matches OEM thread size and length for direct replacement when the original screw is missing or damaged
• Safe for interior and exterior appliance applications where an 8-18 machine screw is used

• Turn off and unplug the appliance before replacing any fasteners
• Use the correct screwdriver or bit to avoid stripping the head
• Install in the same location and orientation as the original screw; do not overtighten
• If replacing screws in structural or load-bearing locations, all surrounding fasteners are secure

The Washer Drain Hose is an OEM replacement part for Frigidaire washing machines. It is a flexible, 7 ½ ft plastic hose that connects the washer tub to the household drainage system. The drain hose removes water from the washer at the end of each cycle.

Symptoms of a faulty drain hose include:

• Water failing to fully drain or continuously draining
• Wet  flooring around the washer due to leaks
• Excess water left standing in the washer tub after cycles
• Reduced washing performance due to inadequate drainage

Causes of a bad drain hose include kinks or bends that restrict water flow, cracks or holes from wear and tear, and blockages from accumulated debris. These issues can compromise the hose's ability to drain water properly.

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This OEM replacement part is a drive motor for washers. The drive motor is the main engine that propels the washer tub to spin and perform its primary function of washing clothes. Over time, a drive motor can lose power or stop working altogether due to excessive wear and tear. If the washer is no longer spinning or not working as efficiently as it once did, the drive motor will need to be replaced. Thankfully, replacing this part is a relatively easy fix.To begin, start by unplugging the washer. Once unplugged, move the washer away from the wall to gain access to the back panel. Uninstall the back panel by removing the mounting screws. Once removed, gain access to the drive motor and remove the screws that attach it to the washer. After unthreading the screws, pull the drive motor out of its place and position the new motor in its original position. Fasten the mounting screws and make sure the motor is securely attached. This genuine replacement part is sold individually and is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore brand washers.