Kenmore Washer 417.44042400 (41744042400, 417 44042400) Parts

This wiring harness connects the control panel to the oven's main control, delivering power and signal paths so the console and electronic controls operate correctly. It restores reliable button, display, and control communication when the harness is damaged. What it does:

• Routes power and signal lines between the control/console and main control board
• Replaces frayed, burned, or interrupted wires that cause unresponsive buttons or intermittent control behavior
• Helps restore normal display illumination and keypad response when the original harness is faulty
• Maintains proper connector fit and strain relief to prevent shorts or loose connections

• One wiring harness for the control panel

• Disconnect power to the appliance before beginning any repair to avoid shock or injury
• Document or photograph wiring locations before removal to ensure correct reinstallation
• Handle connectors by the housings; avoid pulling on wires to prevent damage
• After installation, restore power and test all control functions before reassembling outer panels

This 8-18 x 2.000 screw secures appliance panels and components, providing a reliable fastener replacement for restoring proper fit and reducing rattles or loose parts. Use where the original long 8-18 screw is required. What it does:

• Fastens appliance panels, brackets, or components where an 8-18 x 2.000 screw is specified
• Restores secure mounting to stop panel movement, rattling, or misalignment
• Matches OEM thread size and length for direct replacement when the original screw is missing or damaged
• Safe for interior and exterior appliance applications where an 8-18 machine screw is used

• Turn off and unplug the appliance before replacing any fasteners
• Use the correct screwdriver or bit to avoid stripping the head
• Install in the same location and orientation as the original screw; do not overtighten
• If replacing screws in structural or load-bearing locations, all surrounding fasteners are secure

This OEM replacement part is a drive motor for washers. The drive motor is the main engine that propels the washer tub to spin and perform its primary function of washing clothes. Over time, a drive motor can lose power or stop working altogether due to excessive wear and tear. If the washer is no longer spinning or not working as efficiently as it once did, the drive motor will need to be replaced. Thankfully, replacing this part is a relatively easy fix.To begin, start by unplugging the washer. Once unplugged, move the washer away from the wall to gain access to the back panel. Uninstall the back panel by removing the mounting screws. Once removed, gain access to the drive motor and remove the screws that attach it to the washer. After unthreading the screws, pull the drive motor out of its place and position the new motor in its original position. Fasten the mounting screws and make sure the motor is securely attached. This genuine replacement part is sold individually and is compatible with Frigidaire, Electrolux, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore brand washers.