Kenmore Washer Dryer Combo 417.97862791 (41797862791, 417 97862791) Parts

This door gasket creates a tight seal around the refrigerator door to help maintain proper cooling and reduce energy loss. Replacing a worn gasket restores a full seal for better temperature control and food preservation. What it does:

• Seals the door to prevent warm, humid air from entering the refrigerated compartment
• Helps reduce frost buildup and keeps interior temperatures stable
• Improves cooling efficiency and can lower energy use caused by a leaking seal
• Stops odors and moisture transfer between the fridge interior and kitchen

• Unplug the refrigerator before starting and remove any food or shelves blocking the seal.
• Work slowly to avoid stretching or creasing the gasket; follow door-hinge or trim removal steps if needed.
• Inspect the door flange for damage and clean the mating surface before installing the new gasket.
• After installation, allow the gasket to seat fully and check for uniform contact around the door; warm-up or seating time may be needed.

A replacement union hex nut that secures a refrigerator water line or tubing to a mating valve or fitting, restoring a tight, leak-free connection. Simple, serviceable fastener used on water and refrigeration line unions. What it does

• Secures tubing or line to a mating union fitting or valve to maintain a sealed connection
• Stops leaks at the union when worn or damaged nuts allow seepage
• Helps restore proper water flow to dispenser or ice maker when connection is the cause
• Works with compatible refrigerator water and refrigeration line unions

• One union hex nut

• Shut off the refrigerator water supply before starting work
• Tip: loosen slowly and re-tighten by hand then wrench to avoid overtightening and damaging tubing
• If replacing a corroded nut, inspect the ferrule/sleeve and mating fitting and replace if damaged

A replacement pump mounting bracket that secures the appliance drain/pump assembly to the cabinet, restoring proper alignment and reducing movement that can cause noise or leaks. Direct-fit design for correct positioning. What it does:

• Secures the pump/drain assembly to the appliance frame to prevent shifting
• Keeps the pump aligned for reliable water flow and quiet operation
• Helps reduce vibration and rubbing that can cause noise or premature wear
• Supports proper sealing to help prevent water leaks around the pump area

• One pump mounting bracket

• Disconnect power (and water if applicable) before starting any repair
• Basic hand tools are typically required; remove access panels to reach the pump area
• Inspect related fasteners and gaskets; replace any damaged hardware for a secure fit