Kenmore Dishwasher 587.14249990 (58714249990, 587 14249990) Parts

Genuine Frigidaire part

Knob - Timer

By: Frigidaire

Part Number: 154236401

Genuine Frigidaire part

Timer

By: Frigidaire

Part Number: 154349902

Genuine Frigidaire part

Panel - Control, Black

By: Frigidaire

Part Number: 154357601

Genuine Frigidaire part

Leveling Leg

5.0 (2)

By: Frigidaire

Part Number: 154419301

Threaded

Do-It-Yourself Stories from Customers like You Missing rear legs and needed mounting kit. Frank H. • Louisville , KY • October 31, 2020

Screwed legs into the frame and added the mounting kit to side of the dishwasher. Read more

Genuine Frigidaire part

Switch

By: Frigidaire

Part Number: 154470101

Genuine Frigidaire part

Bushing

By: Frigidaire

Part Number: 154671501

Genuine Frigidaire part

Float

5.0 (1)

By: Frigidaire

Part Number: 154767801

Do-It-Yourself Stories from Customers like You It leaked really bad John L. • Ashdown , AR • December 02, 2016

I put in 4 new parts ad gave it a try. had water under dish washer about the size of a half dollar , I dried it up and washed more dishes and pots. No leak that time, and it has been doing fine since. I'd say water was just what was laying on the water lines and shook off. If you see water the first time don't worry wipe it up and use it some more to see if it leaks. GOOD LUCK!!! Read more

Genuine Frigidaire part

Seal

By: Frigidaire

Part Number: 5300803903

Genuine Frigidaire part

O-Ring (Sealing Gasket), Single

By: Frigidaire

Part Number: 5300806521

This O-ring is a small rubber sealing gasket that prevents water leaks at a refrigerator water connection. It restores a watertight seal to stop drips and maintain proper water flow to the dispenser/ice system. What it does:

Creates a watertight seal at a water line or valve connection
Helps stop visible dripping or slow leaks from fittings
Maintains proper pressure and flow by preventing bypass around a joint
Used where a compressible seal is required between two mating parts

What's included: One O-ring sealing gasket Install notes:

Shut off water supply and disconnect power before servicing
Replace only with the correct-size O-ring and seat it evenly in the groove
Inspect mating surfaces for nicks or debris; clean before installing the new O-ring
Tighten fittings to manufacturer torque recommendations to avoid over-compression