Kenmore Dishwasher 587.1487580 (5871487580, 587 1487580) Parts

A single #8A x 1/2" screw used to fasten trim, panels, and internal components on compatible appliances. Small but essential, it restores secure mounting and stops loose parts from rattling or shifting. What it does:

• Secures panels, brackets, and trim to the appliance chassis
• Replaces missing, stripped, or corroded screws that cause rattling or loose fittings
• Provides proper thread engagement for consistent, reliable fastening
• Helps maintain alignment of components that depend on a correctly sized screw

• Disconnect power to the appliance before working on any electrical or mechanical components
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and avoid overtightening; snug is usually sufficient for sheet-metal fastening
• Keep removed fasteners in a small container to avoid loss during reassembly

This is a single hex nut used to secure components on Frigidaire appliance assemblies. It provides a reliable threaded connection to hold panels, brackets, or hardware in place and helps prevent vibration-related loosening. What it does:

• Secures mating threaded parts so assemblies stay tight during normal use
• Prevents panels, trim, or brackets from shifting or rattling
• Replaces a corroded, stripped, or missing nut that causes loose hardware
• Works where a standard hex nut is specified by the manufacturer

• Unplug or disconnect power to the appliance before servicing
• Use the correct socket or wrench size to avoid rounding the nut
• Hand-start threads to avoid cross-threading; tighten to manufacturer torque if specified
• Inspect mating bolt/stud for damage and replace if threads are worn

This replacement mounting screw secures panels and components in compatible Frigidaire appliances, helping restore stable assembly and safe operation. It's a direct-fit fastener used where the original screw has been lost or damaged. What it does

• Fastens appliance panels, brackets, and small parts to restore secure assembly
• Replaces stripped, rusted, or missing screws that can cause rattling or loose components
• Matches the OEM fit for reliable retention and alignment during normal use

• Use the correct size driver to avoid stripping the head; tighten until snug but do not overtighten
• Disconnect power or follow appliance-specific safety procedures if working near electrical components
• Inspect surrounding hardware and replace as needed