Kenmore Dishwasher 587.1507180 (5871507180, 587 1507180) Parts

This replacement mounting screw secures panels and components in compatible Frigidaire appliances, helping restore stable assembly and safe operation. It's a direct-fit fastener used where the original screw has been lost or damaged. What it does

• Fastens appliance panels, brackets, and small parts to restore secure assembly
• Replaces stripped, rusted, or missing screws that can cause rattling or loose components
• Matches the OEM fit for reliable retention and alignment during normal use

• Use the correct size driver to avoid stripping the head; tighten until snug but do not overtighten
• Disconnect power or follow appliance-specific safety procedures if working near electrical components
• Inspect surrounding hardware and replace as needed

This motor/pump is a replacement drain pump assembly for dishwashers, helping remove standing water from the tub so cycles can complete and dishes can drain properly. Durable pump housing with integrated motor reduces the need for multiple parts. What it does:

• Pumps wastewater from the dishwasher tub to the drain line so the appliance can empty between cycles
• Helps prevent standing water and improves rinse/drain performance
• Replaces a worn or noisy pump/motor that may cause incomplete draining or error codes related to drain issues
• Restores proper water flow when original pump has failed or seized

• Disconnect power and water to the appliance before beginning any repair
• Access may require removal of the dishwasher kickplate or lower access panel
• Verify wiring and hose routing match the old unit before final fastening; reuse gaskets if undamaged or replace as needed

These mounting screws secure assemblies and panels so components stay aligned and stable during normal use. Durable plated steel fasteners help maintain a proper fit and keep parts from loosening over time. What it does:

• Fastens panels, brackets, or components to the appliance frame or assemblies
• Keeps moving parts aligned to prevent vibration and rattling
• Replaces missing or stripped mounting hardware that can cause loose doors or panels
• Used wherever the original mounting screws were removed or damaged

• Turn power off and unplug the appliance before beginning any repair.
• Use the correct screwdriver or bit to avoid stripping the screw head.
• Replace only the screws removed from the same location; match size and thread when possible.
• If a screw hole is damaged or loose, inspect the surrounding area and repair per OEM guidance.

This rubber grommet cushions and secures appliance components where they pass through panels or mount to frames, reducing vibration and protecting wiring or hoses from abrasion. It helps restore quiet operation and stable mounting. What it does:

• Cushions mounts and reduces vibration or rattling from motors or panels
• Protects wires, hoses, and tubing from chafing where they pass through openings
• Keeps components properly positioned to prevent wear and noise
• Worn or missing grommets can cause rubbing, vibration noise, or movement of parts

• One rubber grommet as shown

• Disconnect power to the appliance before servicing
• Remove the damaged grommet and install the replacement in the same orientation
• No special tools typically required; small pliers or a flat tool can help seat tight grommets
• Inspect surrounding seals, wiring, and mounting hardware while replacing