Kenmore Refrigerator 596.69279991 (59669279991, 596 69279991) Parts

Genuine Whirlpool part

Main Control Harness (Wire Harness)

By: Whirlpool

Part Number: 12458101

This main control harness routes power and signals between the appliance control board and components to restore reliable electrical connections and control functions. Replaces a damaged or burnt control wiring harness to help the appliance respond correctly to control inputs. What it does:

Connects the main control board to switches, sensors, and power lines to enable normal control operation
Commonly replaced for intermittent controls, burned connectors, or visible wiring damage
Restores proper signal and power transmission when connector pins are loose or corroded
Helps eliminate control-related failures tied to broken or shorted wiring

What's included:

One main control wire harness as shown

Install notes:

Disconnect power before servicing to avoid shock or damage
Match connector shapes and routing to original harness; secure with existing clips or ties
Inspect mating connectors and terminals for damage; replace if necessary

$20.27

Compare At:: $22.30
You Save:: $2.03

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Grommet - Screw

By: Whirlpool

Part Number: M0581001

$5.46

Compare At:: $6.01
You Save:: $0.55

Out Of Stock

Usually ships within 4 - 14 days

Add to Cart

Genuine Whirlpool part

Overload (Thermal Protector)

5.0 (1)

By: Whirlpool

Part Number: WP4344040

This overload is a thermal protection device that mounts on the motor/compressor and opens the circuit when excessive heat or current is detected. Replacing a weak or failed overload helps restore safe startup and protects the windings from damage. What it does:

Monitors motor/compressor temperature and current draw
Interrupts power on overheat/overload to prevent damage
Aids troubleshooting of start/run issues when paired with the start device
Common symptoms: hums then clicks off, won't start, intermittent shutdown, frequent tripping

What's included:

1 thermal overload protector

Install notes:

Disconnect power before servicing; allow components to cool
Access the terminal area on the motor/compressor; remove any cover
Note/photograph wire positions; transfer wires and fully seat the new overload on the correct terminal
Inspect the start relay, capacitor, and terminals for heat damage; replace any compromised parts

Do-It-Yourself Stories from Customers like You The unit was not cooling. Todd V. • Riverside , CA • May 13, 2023

Replaced the compressor's Overload and Start Relay. Read more

Genuine Whirlpool part

Stop-Door

5.0 (2)

By: Whirlpool

Part Number: W11708403

Do-It-Yourself Stories from Customers like You Door not stopping Jacqueline D. • Marlborough , MA • August 10, 2015

Ordered new bracket two screws easy fix Read more

Genuine Whirlpool part

Rear Roller

By: Whirlpool

Part Number: 10450701

Genuine Whirlpool part

Toe Grille Clip (Retainer)

5.0 (2)

By: Whirlpool

Part Number: WP10551502

A small replacement clip-style retainer that secures the appliance toe grille to the cabinet, keeping the grille flush and in place. Replaces worn or broken clips to restore proper fit and appearance. What it does:

Secures the toe/grille panel to the appliance cabinet so the grille stays aligned and snug
Stops the grille from sagging, rattling, or popping off during use
Fits into designated mounting slots or tabs to lock the grille in place
Commonly replaced when clips are cracked, missing, or loose

What's included: One toe grille clip Install notes:

Disconnect power to the appliance before servicing to avoid shock or injury
Access the toe grille by removing any screws or releasing retaining tabs per your model's service instructions
Press the clip into the grille/cabinet mounting slot until it snaps in place; verify the grille seats evenly
If multiple clips are damaged, replace all needed clips for a secure fit

Do-It-Yourself Stories from Customers like You Kick grill was broken Mike M. • Hillsboro , OR • June 05, 2017

New grill and clips. Was glad I got new clips rather than trying to reuse the old ones. Requires a lot of force to install, but is all nice and fixed now! Read more

Genuine Whirlpool part

Gasket, Refrigerator Dr(Black)

By: Whirlpool

Part Number: WP12550108Q

Genuine Whirlpool part

Retainer-

5.0 (4)

By: Whirlpool

Part Number: WP10183120

Do-It-Yourself Stories from Customers like You Broken shelf Don M. • Berthoud , CO • August 31, 2016

Replaced Read more

Genuine Whirlpool part

Pan-Meatke

By: Whirlpool

Part Number: 10417018

Genuine Whirlpool part

Tray- Egg

By: Whirlpool

Part Number: 10436506

Genuine Whirlpool part

Rack-Wine

5.0 (2)

By: Whirlpool

Part Number: 10448903V

Do-It-Yourself Stories from Customers like You It was missing the front handle of two freezer baskets Daniela O. • Park Ridge , IL • November 17, 2014

Went to chat and chose the two handles that were specifically for my model GE Profile Refrigerator. The items came in two days and the fix was super easy. HOWEVER, for some reason the baskets in MY GE fridge must not be original because the handles were too short. I decided to keep them and work with them as without anything there the food would just slide out. APP were very helpful and even looked to other online sellers and the replacement part for my unit was correct. We came to the... Read more

Genuine Whirlpool part

Kickplate/Wht

4.5 (2)

By: Whirlpool

Part Number: 10474802

Do-It-Yourself Stories from Customers like You Refrigerator gasket were ripped and worn Ken R. • Salem , OR • September 15, 2016

The video was generic but very good. I started trying to tuck the gasket like the video was showing, but soon gave up and pulled the screws around the door, the gasket snapped on and put screws back in. I know some viewers said they simply loosened the screws but I found it just as simple to remove them and the gasket snapped into place and had no issues with screw hole alignment. Read more