Kenmore Refrigerator 596.77532600 (59677532600, 596 77532600) Parts

This replacement screw fastens internal components and panels so parts stay secure and quiet. It's a direct-fit fastener used where the original mounting screw is missing or damaged to restore proper assembly. What it does:

• Secures panels, brackets or components to prevent movement and vibration
• Restores proper alignment for covers and access panels
• Stops rattling or loose-fitting parts caused by a missing or stripped screw
• Works as the factory-specified fastener for the original mounting point

• The screw location and type before installing; use the original hole and thread
• Power off and disconnect the appliance before accessing internal components
• Start the screw by hand to avoid cross-threading, then snug with the appropriate screwdriver
• Do not overtighten — stop once the part is secure to avoid stripping or cracking

This genuine replacement door gasket creates an airtight seal around the refrigerator door to help maintain proper temperature and efficiency. It restores sealing performance to reduce frost buildup and stabilize internal cooling. What it does:

• Seals the refrigerator door edge to keep cold air in and warm air out
• Helps prevent frost and ice buildup in the freezer/refrigerator compartment
• Reduces compressor run time caused by a leaking door seal
• Improves temperature consistency for food preservation

• Disconnect power to the appliance before starting any work
• Clean and dry the door flange thoroughly before installing the new gasket
• Press the gasket into the channel evenly, working around the door to align the magnetic lip
• Inspect the seal after installation and allow normal operation to seat the gasket; check for gaps and re-seat if needed

This water filter cover secures and seals the refrigerator's replaceable water filter, helping maintain correct water flow and prevent leaks. It restores a snug fit after filter changes for reliable dispensing. What it does:

• Secures the replaceable water filter in its housing and holds it in place
• Seals the filter area to help prevent water leaks around the filter
• Directs water through the filter for proper flow and filtration
• Can resolve symptoms like a loose or unseated filter, leaks near the filter housing, or difficulty installing the filter

• Turn off the refrigerator water supply and dispense remaining water before starting
• Remove the existing filter per manufacturer instructions, then position and snap or twist the cover into place
• Inspect filter O-rings and housing for damage; replace damaged seals before reinstalling

This outer cabinet housing provides a durable structural shell that supports internal components and protects them from debris and wear. It restores proper alignment and enclosure for safe, stable appliance operation. What it does:

• Replaces a cracked, dented, or misshapen outer housing that can allow debris or moisture into the appliance
• Restores proper mounting surfaces and clearances for panels, controls, and internal assemblies
• Helps reduce rattling or vibration caused by a compromised cabinet
• Prevents exposure of internal wiring and components to contaminants

• One outer cabinet housing

• Recommended for experienced DIYers; some disassembly of panels and components is required
• Disconnect power and any water lines before beginning work
• Keep track of screws and brackets; some fasteners may be reused

This cover is a replacement cabinet trim piece that restores the appliance's exterior finish and protects underlying components from dust and damage. It provides a clean, finished look and helps maintain proper airflow around the unit. What it does

• Covers and protects exposed cabinet openings or component access points
• Hides fasteners and internal parts for a finished exterior appearance
• Prevents dust and debris from entering service areas
• Helps maintain proper airflow pathways by closing gaps

• One cover cabinet trim piece as pictured

• Intended for basic exterior replacement; verify orientation before fastening
• Use appropriate screws or clips removed from the original piece; do not force
• Disconnect power (and gas if applicable) and follow all safety precautions before servicing