Kenmore Dishwasher 665.13263K110 (66513263K110, 665 13263K110) Parts

This replacement silverware basket sits in the dishwasher rack and keeps forks, knives, and spoons upright and contained so they wash thoroughly and don't slip through the rack or interfere with spray-arm movement. What it does:

• Holds and organizes flatware during wash and rinse cycles
• Helps separate utensils for better spray coverage and drainage
• Replaces cracked, warped, or missing baskets

• 1 silverware basket

• Open the dishwasher and pull out the lower rack for access
• Lift out the old basket and place the new basket in the same location/orientation
• Ensure the basket seats securely and does not contact the lower spray arm
• Manually spin the spray arm to confirm clearance before running a cycle

This handle pocket is the small insert that finishes the end of select appliance door handles and retains the KM 2.5-inch medallion. Replace a cracked or missing pocket to restore a secure hold and a clean, factory look.

• Retains the KM 2.5-in medallion at the handle end
• Provides a finished appearance and helps cover internal fasteners
• Helps keep the handle end secure to reduce looseness or rattles
• Typical symptoms: loose or missing medallion, cracked pocket, damaged/unfinished handle end

• Disconnect power to the appliance before servicing
• Access the handle end; remove any set screw(s) or trim as required
• Seat the new pocket, transfer the existing medallion, and resecure hardware
• Do not overtighten fasteners; verify the handle is secure and aligned

This console assembly replaces the dryer control console to restore a finished front panel and allow access to the machine's controls. It provides the mounting surface and openings for the control board, timer, and user interface. What it does:

• Replaces a cracked, faded, or damaged control console to improve appearance and function
• Secures and protects the control board, timer, and user interface components
• Restores proper alignment and access to control knobs, buttons and display openings
• Helps resolve issues caused by loose or broken console mounting that affect button or knob operation

• One console assembly

• Power off and unplug the appliance before beginning work to avoid electrical shock
• Handle the console carefully to avoid scratching the finish and damaging clips or mounting tabs

This insulated wire lead carries electrical current between components, restoring reliable power routing in your appliance. It's a direct-replacement discrete wire used where a single conductor is required for safe operation. What it does:

• Provides a single insulated conductor to connect terminals or components
• Restores proper electrical continuity when a wire is damaged, burned, or disconnected
• Helps prevent shorts by maintaining insulation between conductors
• Suitable for low- to moderate-current wiring routes within the appliance

• One insulated wire lead as shown

• Disconnect power before inspecting or replacing wiring to avoid shock or injury
• Route the wire as the original, avoiding sharp edges and heat sources; secure with existing clips or ties
• Replace any damaged terminals, connectors, or fasteners; use correct crimps or solder joints per OEM practice

Color: Biscuit. Size: 1 qt. can uncut. Enamel paint.

Color: White. Other colors: For black use 8171657, for biscuit use 8171657.For stainless use 8171659

Color: Black. Other colors: For white use 8171656, for biscuit use 8171657, for stainless steel use 8171659.

Color: Stainless steel. Other colors: For black use 8171657, for white use 8171656, for biscuit use 8171658.