Kenmore Range 790.7482190 (7907482190, 790 7482190) Parts

Shoulder screw secures oven components with built-in spacer for proper alignment. Replace worn, missing, or stripped fasteners to restore fit.

Wing nuts for ovens and ranges. Used to secure panels, brackets, and internal components. Replace if stripped, corroded, or missing during repair work.

Replacement burner top for your range cooktop. Installs on the surface where cookware sits. Replace if cracked, corroded, or worn to restore appearance.

Fix a burner that won't light, won't adjust, or stays on with this range top burner valve. Controls gas flow to surface burners. Moderate DIY repair.

Replace your cracked or broken range valve cover. This protective housing installs over the gas valve assembly to shield internal components from damage.

Replacement roller for oven storage or warming drawers. Needed when drawer wheels are cracked, broken, or missing causing difficulty opening or closing.

Support rod that holds the cooktop top in place. Replace this structural pin if the original is broken, bent, or missing to properly secure the top.

Anti-tip bracket mounts to the floor behind your range to prevent tipping when weight is applied to the open door. Replace if bracket is missing or damaged.

Drawer assembly for ovens and ranges. Replaces broken, cracked, or damaged drawer components. Essential for restoring storage functionality.

Replacement inner door glass panel for your microwave. Installs between door frames. Order when original glass is cracked, shattered, or broken.

Replace your range's griddle cover if it's cracked, broken, or missing. This protective cover installs over the griddle surface on your cooktop.

This snap bushing is a push-in grommet that secures and protects wiring where it passes through sheet metal openings, helping prevent wire chafing and wear. It's a simple replacement that restores proper wire routing and protection. What it does:

• Holds wiring or harnesses in place at panel openings to prevent rubbing and abrasion
• Cushions wires against sharp edges to reduce the risk of wire damage and shorts
• Maintains correct wire routing to prevent pinching when panels are reassembled
• Common symptom: visible chafed insulation or loose wiring at an opening

• One snap bushing (quantity: 1)

• Disconnect power to the appliance before beginning any work to avoid shock or injury
• Access the panel or opening where the wiring passes through; remove any retaining screws or clips as needed
• Press the bushing into the hole until it snaps fully into place, then route the wire through the center
• Inspect surrounding wire insulation and replace or repair any damaged wiring before reassembly

This retainer secures appliance insulation panels to the cabinet, helping keep insulation in place so the unit maintains proper temperature and reduces drafts. Durable plastic construction designed to fit OEM mounting points. What it does

• Holds insulation firmly against cabinet walls to prevent shifting or sagging
• Helps stop cold spots and uneven cooling caused by displaced insulation
• Reduces vibration noise from loose insulation material
• Commonly replaced when clips break, crack, or fail to grip

• One insulation retainer

• Disconnect power before working on the appliance to avoid shock
• Access may require removing interior panels or liners; save fasteners for reassembly
• Replace any damaged surrounding clips or seals to restore a proper fit
• If you encounter rusted or seized fasteners, use appropriate tools and corrosion-penetrating lubricant; avoid forcing parts