Steven February 19, 2020 for Model Number FFLG3911QW0 STACKABLE WASHER DRYER TURN ON WASHER FILLS BEEP3 TIMES.WENT TO RINSE AND SPIN DRAINS NO PROBLEM.LET FILL ON NORMAL CYCLE WASHER FILLED THEN BEEP 3 TIMES NOTHING HAPPENED.PEASE HELP STEVE
1 Answer Steven, You will want to put the unit into a diagnostic mode and see if there are any stored error codes. Check the tech sheet for the error and this will guide you to what you need to check. Read More...
Iblashaun June 15, 2019 for Model Number FFLE3911QW0 Frigidaire stackable number 30 on parts diagram control-electric oblong box goes in back i figured out most plugs had to go (only fit one place but there is four on top and not sure where to put plug afraid if i put wrong one on might burn my board up Can anyone tell me what colored wired plug goes where?
1 Answer Iblashaun, Next to each connector on the board there will be a number letter combination specifying what connector it is. The user interface board wire which are Black yellow Red and orange connector will go to the J17 connector on the board. White wire from the dryer connector will go to the J1-1 and the black wire from the dryer connector will be J1-2. the Lid lock which will be 2 grey and 1 black will go to connector J13, black on J13-1 the grey on the other 2. The water valve which has 2 blue and 2 white will go on Connector J18 and the blue will be pins 1 and 3 and the white on pins 4 and 6. Coming from the motor control unit there will be 5 wires 3 blue which will go to the J16 connector, and 2 grey which will go to the J12 connector. The clutch actuator will have 2 wires a white and a black which the white will go to the J20 pin 6 and the black will go to J9 pin 1. The drain pump motor has 2 orange wires that will go to the J15 connector pins 3 and 4. Read More...
Dave February 24, 2018 for Model Number FFLE3911QW Frigidaire laundry center. Dryer works. Washer won't do anything at all. Any ideas?
1 Answer Dave, If the washer is not filling or doing anything then you will want to check to see if the water valve is getting power to it. If it is not then this will most likely be the control board for the washer that is faulty. Read More...