Scott & Cala January 23, 2019 i need to convert my fridgidaire washer/dryer model FFLG3911QW1 from natural gas to lp. Which kit do I use. PCK3100 OR PCK2003
1 Answer Hello Scott, the correct conversion kit for the model number supplied is part number PCK3100. Thanks! Read More...
Jessica August 04, 2016 for Model Number GE WSM2780WAWWW Hi I have the natural to LP conversion kit PCK3100. My question is on the original assembly I have the flame spreader type burner, but a ice cream type burner is included with the kit. Do I have to change those out? If so, can you explain how to use the adaptor included in the kit to get from the flame spreader to the ice cream scoop type burner? The instructions are very vague and the picture included is not legible. Thanks in advance for the help!
1 Answer Hello Jessica. Yes, you will replace the burner. Disconnect electrical power supply to laundry center. Shut off the gas at the individual shut off valve. Gain access to the valve by removing the dryer access panel, dryer safety cover and dropping the console assembly. Loosen the valve union fitting. Remove the screws that fastens the burner assembly to the access shield of the dryer. Disconnect the 2 molex (plastic) connectors from the gas valve. Disconnect the 2 wires that connect to the radiant sensor. Remove the burner assembly from the dryer. Remove the screws that fasten the burner tube and heat shield to the main mounting bracket. Remove the screws that fasten the burner to the main mounting bracket. Remove the original orifice from the gas valve assembly and install the new orifice (#55) from this kit. Tighten securely. Remove the leak limiter and install the L.P. blocking pin. Note: Save the original parts (orifice & leak limiter, items 1 & 2) in case it is required to convert the dryer back to natural gas. Assemble the adapter to the main mounting bracket. Assemble the air shutter to the stainless steel burner. with one (1) small #8 screw. Adjust the air shutter to a 3/8” opening and tighten. Assemble the ignitor to the adapter with one (1) small #8 screw. Connect the ignitor harness to the adapter with the push mount cable tie. Cut off excess strap. Assemble the stainless steel burner w/air shutter to the adapter with the two (2) large #10 screws. Assemble the burner tube and heat shield to the main mounting bracket. Affix the red conversion label to the shut-off valve. Read More...
Darin O November 04, 2015 for Model Number FASG7074LW0 Need a conversion kit from LP to Natural gas for FASG7074LW0
1 Answer Darin, In order to convert the unit back to natural gas you would need to replace the gas valve on this unit as the conversion kit to natural has been discontinued. Read More...
Jackie October 27, 2015 I need to convert my three year old dryer BACK to natural gas from LP. I have been told repeatedly that the installers should have left the original parts here when they did the conversion to LP, but that isn't the case
1 Answer Jackie, Since the original Nat gas parts were not saved, chances are you will need to order and install a complete gas valve for your dryer. If you can get us a model number of your machine, we can research and check to see if individual parts are available, and or get you the part number and conversion information you'll need. Read More...
William H September 14, 2015 for Model Number Pro - Com model QN300TYLA fire place I need a natural gas to LP fireplace conversion kit do you have them and how much are they.
Ronald K. November 07, 2011 for Model Number 417.99175110 I'm looking for a kit to convert my dryer to propane from nat gas. Is Part no. ap3746586 correct?
1 Answer Hello Ronald! The conversion kit to convert your appliance over to LP is part number PCK3100. Thanks. Read More...