Chuck October 04, 2022 for Model Number FSC23LR5JM1 No lights on refrigerator side. Line voltage at main power board J3. J3 pin for lights 20 volts, bad board? Could something else be loading it done? Membrane issue? Thanks
1 Answer Chuck, If you are getting 20 vac from the control board to the lights then this will be a faulty control board. Read More...
Jeff September 29, 2018 for Model Number Fsc23lr5jm1 No display illumination of temp in either compartment. Freezer light works. Fridge light inop No activity from fan or compressor. and temp is rising in both units. suspect main power board ?
1 Answer Jeff, it certainly could be the main power board located under the front of the refrigertator, part number is 241511101 Read More...
Dan September 25, 2018 for Model Number circut board#2414511101 I have a Kenmore elite side by side about 2010 . plug it in it will come on every thing seems to working compreser condenser fan lights ect. After about 1 min. it shuts down and says PF on the display.
1 Answer Dan, I need you to re-submit your quest and include the model number of your refrigerator. Thank You Read More...
P Myers August 01, 2017 for Model Number E128BS561S5 My temperature is at 54 degrees inside fridge. When I set the external temp, it goes back to 54. The freezer is fine at 0 degrees. Is my control board bad? It is just 6 years old. The temp has always been 34 degrees and freezer 0. Thank you.
1 Answer P Myers, The display will show the the actual temperature and you will want to check to make sure that the unit is not having a defrost issue. Remove the rear wall in the freezer and check for a evaporator being completely iced up. If it is then check the defrost heater and the defrost thermostat to make sure that they are good. If they are then the control board would be the issue. Read More...
Vicky January 18, 2017 for Model Number FGHS2631PE2 My frigidaire gallery refrigerator has no power after the breaker blow. No power at all. No control panel, nothing works.
1 Answer Vicky, This issue will most likely be caused by a faulty main control board that would need to be replaced. Read More...
Ignacio February 10, 2016 for Model Number E23CS75DSS1 Hi, I'm working on a Electrolux e23cs75dss1, it shows the letters E and F at fridge and refrigerator display, and it was beeping every 10 min, more or less, with some 'tac tac' noise like a relay getting on and off. I removed the main board and it seems to be damaged, I took it to a repair center and they told me that the board was broke. I bought a new board and installed it yesterday, the code E/F persists, but not the beep and the 'tac tac' noise either. Some forums says that it might be the evaporator fan, but I saw it running, I open the fridge door and the fan reduce the rpm, the compressor is working, condenser fan its working, the refrigerator is cooling but the E/F code still there. What could be the problem? Thanks!
1 Answer Hello Ignacio. EF is the System Evaporator Fault. This usually means there is NOT enough air flow over the sensor, this can mean a faulty sensor, or evaporator fan motor. If the fan motor is good, replace the sensor. Read More...
Kevin January 02, 2016 for Model Number FSC23R5DWG I have a fridigaire refrigerator model number fsc23r5dwg. We defrosted it over Christmas off for two weeks and pluged it back in it initially made quite a few beeps and the compressor did come on. The refrigerator side lights don't come on and the control panel did not light up. At first the on off button would shut the compressor down but now it does nothing. It has been two days and it is working with the refrigerator side a little warm. I just need some help if you think it is the control panel or the control board.
1 Answer Kevin, With the issues that you are having with the unit, this would most likely be caused by a faulty main control board which is part number 241511101. Read More...
Bailey December 13, 2015 for Model Number fsc23r5dsb3 Unit cooling fine ice dispenser and ice dispenser dead.
1 Answer Hello Bailey. It sounds like the main power board may have failed and will need to be replaced. Read More...
Adam S. August 30, 2015 for Model Number FSC23R5DWD The ice-maker stopped working. Using the power switch toggle to do "manual re-set" resulted in no movement. Checked for voltage at the connector at the ice-maker motor, had no voltage at any lead. Checked for continuity from the power supply to the ice-maker connector. Except for the output (yellow) to the water valve, (I did not check that). The fuse on the board is good as well. I am gathering that the board is bad. Could the ice-maker cause the board to fail?
1 Answer Hello Adam, Any component including the harness can cause a board 241511101 failure. Anything that draws excessive current through the board can be at fault. I would suggest checking for neutral to the icemaker and for 120Vac near the end of the icemaker cycle at the water valve, (about 6 to 7 seconds). Read More...
Jim March 14, 2015 for Model Number FSC23LR5JM1 What's the part number for the main board so I know which one to order?
1 Answer Jim, the main power board listed for your model is part number 241511101. Thanks! Read More...