Customer Questions and Answers for Module-Dispenser by Frigidaire

Marc, Thank you for your question. The manufacturer is not showing the bulb for this unit and it appears that the only way that you can get the bulb is to replace the module 240563639.

Chrissie, Unfortunately, the ice chute door seal is not available as an individual part. You will need to order the 240563638/240563638 Module-dispenser BLK, to receive the seal. The part is in stock and available at this time. Thanks,

Hello David, I'm sorry but 240563609 has been discontinued by the manufacturer and has been replaced with 240563633 240563638 by the manufacturer. 240563609 is no longer available.

Hello David, According to all the information we could pull on this part, 240563638 does include the wiring that attaches to it.

Linda, the dispenser cover is part number 241679003 and cover module is part number 240570237. Thanks.

Joe, You could have a faulty actuator switch 241689106 or selector switch 5304525097 here's some help " To Gain Access To Control Area: 1. Pull drip tray straight out.2. Remove three screws at bottom of front panel.3. Lift up on front panel. There are tabs on top of panel that slide into holes in door panel.4. Swing panel out to side, being careful not to pull wires out of disconnect plug or control board. 5. Carefully unplug wiring harness from control board on front cover. This gives access to power board. NOTE: On models with no selector on the front panel, once the front panel has been removed, you can gain access directly to the dispenser because there is no control board or power board.6. With the board detached, remove three screws from dispenser housing and pull housing forward.7. Remove water line from dispenser housing by pulling straight out.With the water line removed, the upper part of the dispenser is free of the freezer door panel.The main housing is built into the door panel and is not removable. The ice door, actuator switches, and return springs can be serviced with control module removed.The door closer is mounted on the side of the housing and is connected to the door arm with a gear wheel to slow the closing of the door and allow enough time for the ice to clear the chute.The door takes approximately 20 seconds to close after the glass is removed from the actuator.Both the water and ice actuators are tensioned by a stainless steel, two bladed spring which is mounted behind the actuator switches. The spring is held in place by two screws.The actuators are held in place by stainless steel clamps at each end of the actuator and the two bladed spring in the middle. The actuators can be detached by removing four screws and lifting the paddle/ice chute out of the housing.On models that dispense only water and ice cubes, the dispenser comes apart the same way as on models with a control board. The difference is, there is no light in the housing and the wiring to the actuator switches is connected directly to the plug in the door wiring harness." Thanks and Good Luck

Hi Gary. Unfortunately our search engines are having difficulty finding the model # provided. Can you please double - check it and send it once more. Thank you.