Sergio June 03, 2019 for Model Number fafw3801lw the door boot seat have small hole and the water is came under wash do you think I'm need replacement
1 Answer Sergio, If there is a hole in the bellows and the unit is leaking then yes you will need to replace the door seal.134515300 Read More...
Leo May 04, 2017 for Model Number kenmore 41748112701 do you have the spring clamp retainer which holds the spring in place for kenmore 41748112701? can I just buy that? Thanks!
1 Answer Hello Leo. The spring clamps Matt is using in the video can be purchased from any local hardware store. They are common squeeze clamps. Thank you. Read More...
Kim December 10, 2013 My spring came off of the boot seal(?) and I need to know if this is something that I can put back on myself or is there an underlying problem? My front load frigidaire washer is leaking water. The model number is GLTF2940ES0.
1 Answer Hello Kim. These are very hard to install but can be done. You need to remove the front panel and install the boot onto the tub lip. Then stretch the spring over the boot and lip to secure it. Read More...
Mary July 30, 2013 for Model Number FAFW3517KR1 I have the wire spring but the plastic seal behind it as broke off..I cannot find what it is called or find it on the site or anywhere else..Can you help me??
Jsoder July 26, 2012 for Model Number GLTF2940ESO Can I order only the wire that goes around the gasket? It is completely rusted and falling out causing leaking from the drum.
1 Answer Hello Jsoder! The front clamp is part number 134527100 and the rear is part number 134365300. Thanks! Read More...
Jeff January 04, 2012 for Model Number LTF2140es0 I have removed the bellow and did not realize there was a second spring. Where do I reinstall the spring?
1 Answer Hello Jeff. The spring 134365300 holds the back of the bellow to the outer tub assembly. You will install the bellow on the tub and place the spring on the small lip to hold the bellow onto the tub assembly. These are very tight. Hope this helps. Read More...
Bill H. July 28, 2011 for Model Number 41744152500 I am having difficulty with reinstalling both the spring around bellow and the wire. Any help? Please!
1 Answer Hi Bill. It is easier to start at the bottom half between 4:00 and 8:00 and install lifting up and strtching on at the same time. This way you are rolling the spring up along the topand it will be easiest to use muscles at this position to finish the process. I have seen large men wrestle with this a few times before it finally is on. Hope this helps. Thank you. Read More...