Bill November 29, 2021 for Model Number WHIRLPOOL GAS RANGE MODEL# WFG520S0FSO PART OF LED LITE ON CLOCK IS NOT LIGHTING
1 Answer Bill, With part of the LED not working then this would be a faulty control board that would need to be replaced. Read More...
Ricardo August 30, 2017 for Model Number GTUP270EM1WW Washer is filling, cutting off, and not starting back. Two lights are staying on.
1 Answer Hello Ricardo, This is most likely an issue with the control board WH12X20274. For a more accurate diagnosis, please post a new question that includes the lights that stay on. Read More...
Ray June 14, 2017 for Model Number GTUP270GH1WW I was just communicating with Cindy who has all my information regarding the machines problems and we lost contact, Last thing she said was that she was researching the issue. Please contact me at So we determine the correct parts to purchase. Again the washer has been making a noise when in the spin cycle, and often needs to be tricked into starting the spin cycle by turning off and back on again for the last month or so. Last night the pump turned on in the middle of the night without anyone being near the machine or using it, it now runs continuously until unplugged. Resetting the machine (lifting lid six times) does not do anything to help. The top two LED's were lit, but after tapping the relays on the main board (stuck relay?) the LED's now flash constantly when I plug it in but the pump will still run, both with the selector off or on.
1 Answer Ray, This issue would most likely be caused by a faulty control board for the unit. Read More...
Michael October 06, 2016 for Model Number GTUP270EM1WW Machine won't start, spin light keeps blinking.
1 Answer Michael, The most likely cause for this unit to not start and the spin light blinking would be that either the lid switch is bad or a bad control board. Read More...
Larry June 14, 2016 for Model Number GTUN275GM1WW When washer enters the spin cycle it will not stop spinning
1 Answer Larry, With the unit continuing to spin and not stop then this would most likely be a issue with the control board on the unit which is part number WH18X10002. Read More...
Shaun W August 13, 2015 for Model Number GTUP240EM1WW When I put it in rinse mode on this washer no water comes out and the pump comes on to drain, also when I put it in to wash mode water will come out for a second and then stop and then when I lift the lid up water starts to come out again. any idea what is making it do that? I have changed the mother board and it still does the same thing.
1 Answer Shaun, You will want to check the pressure switch to make sure that the switch is good and test the lid switch to make sure that it is good. If they check ok then the water valve would be the issue. Read More...