1 Answer Hello Susie. If the unit fills with water and the motor runs, but does not spray out any water, you may have a bad impeller kit and need to order and replace part number WD19X10032. Read More...
Robyn October 21, 2011 for Model Number GSD900D-03 My dishes have a lot of "grit" on them after I run them through the dishwasher, no mater how much I rinse them. I think that means I need to change my filter, but I have not idea how to do so or what parts to buy. Please help.
1 Answer Robyn, Checking and cleaning the filter and sump isn't too hard (Remove the lower rack, remove the screw from the rectangular grille on the bottom of the top, behind the lower spary arm, and lift it and the sump cap out, clean and reinstall everything, after you check and clean out the sump housing as best possiblr).You also need to check and make sure the water is hot enough(120 dgrs. minimum on the first fill and the detergent is not too old, low water temperature and old detergent will also leave a "gritty" substance on the dishes, the detergent does't disvolve and break down properly. Thanks and Good Luck Read More...
Marcf July 23, 2011 for Model Number GSD4020Z00BB Could a faulty body valve and check assembly cause standing water to be left after cycle is complete?
1 Answer Hello Marcf. If there is water siphoning back into the dishwasher, then the body valve and check assembly WD22X10024 could be the problem with the unit. If the dishwasher is not draining properly, you will want to check and see if the drain hose or pump assembly is clogged. Hope this helps. Read More...
Yaquelin April 16, 2011 for Model Number GSD3610F00AA Dishwasher How i removed the Body valve and install the new one on the back of my dishwasher
1 Answer Hello Yaquelin. This answer was located on our Repair Forum, this is a free service in which technicians will assist with answering repair questions for our customers. Please use this link to assist in your repair: http://forum.appliancepartspros.com/dishwasher-repair/2956-dishwasher-not-draining.html . Hope this helps! Read More...
1 Answer You will want to make sure the timer is advancing to the drain cycle. If it does you should hear a solenoid located at the bottom click on and the pump come on. You can remove the toe panel on front to verify the solenoid is working. Lastly check the pump for any obstructions not allowing the flappers to function properly. Read More...