Mb April 28, 2018 Large burner on GE gas stove flickers when initially started then eventually ignites all the burners. A portion of the burner has a higher flame than the rest of the burner. Would a new burner be the best solution or is it something else? I have had a service shop come out and they were of no help.
1 Answer MB, You will want to make sure that the burner heads are clean. This will be the most likely cause for this issue. If this checks ok then the issue will most likely be with a partially clogged orifice. Read More...
Ron Selberg January 13, 2017 for Model Number jgp337wej2ww The large burner on my GE stovetop works fine on high flame settings and OK on low flame settings, but doesn't seem to work on medium. It goes from high to flickering to low, no medium flame.
1 Answer Ron, The large surface burner going straight from high heat to low would be a valve issue which would be part number WB21K10057. Read More...
Deborah June 30, 2016 for Model Number PGP966SET4SS I can't seem to find the correct burner/burner cap for this model cook top.
Fritz December 31, 2014 for Model Number JGBP33WEH3WW big burner in front right the flame is way to big last night flames came out around the knob and it started to melt had a hard time turning it off
1 Answer Fritz, You need to check the burner base and cap for any debris, damage, and proper set up and installation. But, it sounds more like the orifice tube WB28K10190 and/or the gas valve WB21K10083 have a gas leak and is causing the flame to seep out and around the underside of the cooktop. Did someone try to raise the cooktop when cleaning the range ? Read More...
Peter December 15, 2013 for Model Number JGSP28WEK4WW Will this burner replace the one I have on JGSP28WEK4WW? Thanks.
1 Answer Peter, burner part number WB16T10046 will fit the large burner only. For the small burner use part number WB16K10070 and medium burners use part number WB16K10055. Thanks! Read More...
Frank December 10, 2013 for Model Number ge pofile spectra xl44 Is this top burner work for the model number that I have?
1 Answer Hello Frank. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Jeff September 26, 2013 for Model Number GE JGBP28DET I am missing a large burner and cap for my gas range. There seems to be 3 sizes: small, medium, and large, but your store only has one size (large). Do you guys just sell the large burner or does this model only have large burners (in which case I might have the wrong model number)? Note: the burners I do have are about 3 inches tall. Also, If the burner is missing Do I need to do anything further than just dropping in the burner over top of the drip tray and then the cap on top of the burner? Thank you!
1 Answer Jeff, I am showing GE JGBP28DET* models have one large burner, one small burner, and three medium burners. The large front right burner is part number WB16T10046. The large burner cap comes in black as part number WB29K10006 or grey part number WB29K10007. You'll need to remove the screws and wiring to the burner in order to remove and replace the burner head. Thanks! Read More...
Deborah S. November 04, 2011 for Model Number 36275201892 I can't lift the stove top. After I remove the screws from each burner are there clips that have to be pushed in and if so where are they located?
1 Answer Hi Deborah. Under the front panel at approx. 3-4" in from the corners. Use a putty knife to insert and release the hold down clips. Rarely are they on the side also. Thank You. Read More...
Guest February 21, 2011 HOW CAN THE BURNER MALFUNCTION? I HAVE ONE THAT WILL NOT IGNITE AND WHEN i MOVE TO THE OTHER LARGE BURNER, IT WILL NOT IGNITE?
1 Answer Check and make sure no debris is on the orifice and the burner is clean. If the ignitor is not sparking then you could have a bad spark module. Read More...