Gerald April 13, 2015 for Model Number JBP64BOH2CT Electric stove top heating element is get as hot. On high it is cooking very slow as if it is on low or medium. What can I do? Gerald
1 Answer Hello Gerald. Make sure the voltage is good on the unit. If so, you will need to order and replace the infinite switch on the unit. Read More...
Donna February 11, 2015 for Model Number unknown I have a used ge range I purchased without a power cord. I found one at supply store,, but I need the SCREWS that hold that cord onto the stove... can I order these?
1 Answer Donna, We would need to have the model number of the range to be able to tell you what the screws part number is for the model if available. Read More...
Sam November 14, 2013 for Model Number SPECTRA ELECTRIC STOVE. JBP26WOB4WW I made a stupid mistake . I tried to remove bake element before unplugging and it sparked. Now I have no lights at all. Which part I need to order. I must have these parts by tomorrow including bake element Thanks
1 Answer Hello Sam. If there is power to the control board WB27T10230, and it does not work, you will need to replace the board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Jerry August 29, 2013 for Model Number JBP82CH1CC Two parts of my GE elec range don't appear to be working, and they both went out at the same time yesterday. ------The oven doesn't heat---neither bake or broil; and the stove top elements don't heat---none of them. ----However, the oven (and clock etc) control touch pad panel appears to have power---lights up, appears to take commands/ input, the clock works, etc----and the rotary switches for each of the stove top elements seem to have power----the indicator lights light up when I turn them to the "on" positions for heating. ---Note; So far, I tried disconnecting the plug for a few minutes and put it back in, and still have the problem. ---------thanks -Jerry unit is GE elect range JBP82CH1CC
1 Answer Hello Jerry. Either the terminal block is burnt, bad power cord, or the breaker is bad and you are only getting 120 volts. Read More...
Sue August 11, 2011 for Model Number RA724K1WH Our cord and terminal block had a melt down. The red wire covering on the stove side is blackened for about an inch. What do we need to do about that?
1 Answer Hello Sue. You will need to cut the burnt part off the wire and crimp on a new terminal. Then install the wire onto the terminal block assembly WB17T10011. Hope this helps. Read More...