Nadine May 26, 2016 for Model Number LG Tromm WM2487HWM My washer does not spin at the speed it is supposed to. It just tumbles starts to spin stops reverses direction and then does the same thing over. Plus when it got to for instance 9 minutes it continued to do this and the time never reduced.
1 Answer Hello Nadine. Make sure the unit is draining properly. If so, then you will need to check the control board on the unit. If the board is bad, then the part needed 6871ER1062G has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
Don September 25, 2014 for Model Number 79642198900 Intermittent wont run (interior light stays on) need wiring diagram.
1 Answer Don, Unfortunately we would not have a wiring diagram for this Sears Kenmore product as the manufacturer does not supply this information. Read More...
Mark October 10, 2013 for Model Number WM2487HRM I have a LG Washer Model WM2487HRM. I removed the back panel and found that the multi wire motor harness has cracked and shorted. Evidently, this also shorted out the main power panel, which I have already replaced. I have attempted to remove this harness but cannot get to all the connections. My question is how do I replace the wire harness (LG part 6877ER1016F)? I cannot get to the ground wire and the connector that are behind the flywheel of the direct drive motor to remove. Do I remove the flywheel or am I missing something?
1 Answer Mark, To remove the wire harness that is behind the stator you would need to remove the stator and rotor. This will allow you access to the screw that holds the ground wire in place. Read More...
Sam August 23, 2013 for Model Number Wn2487hwma When washer goes into spin cycle there is a loud sound as if the motor is straining with a buzzing sound.
1 Answer Hello Sam, This sounds like there is something in the drain pump 4681EA2001T or the recirculation pump 4681EA2001T. Read More...