Mike October 30, 2017 for Model Number DW7933LRABB/AA-0001 When my dishwasher start to fill, the heavy and auto button starts flashing. Is the overfill sensor inside the brake casing? If I replace the casing with the sensor be a part of that.
1 Answer Hello Mike. Yes, it is part of the case assembly. You will need to replace the case break if it is bad. Thank you. Read More...
Angela June 05, 2017 for Model Number DMT400RHS/XAA My dishwasher won't drain, delicate light flashing. I've checked air gap and lines. took apart the inside cleaned both filters, cover, and impeller. Found dishwasher check valve broken and never found the lower half. Reassembled, not sure if I put nozzle duct seal back properly (#6 on diagram). It's flashing Heavy light. So I pulled apart bottom drain pan dried noticed water coming from turbidity sensor cleaned and replaced sensor. Now It won't drain again back to delicate light blinking. The only thing I notice was the Brake Assy has some debris in upper left. Thinking of replacing Drain pump. Thoughts?
1 Answer Angela, The drain pump or the Main control board would be the most likely causes for this issue. The drain pump would be the most common. Read More...
Marie March 13, 2017 for Model Number samsung dmt800 dishwasher Noticed this part looked like it was dirty/ had mildew inside it when my husband replaced a drain hose the other day. should it be replaced? No error messages or anything, just wondering if this part is contaminating my dishes.
1 Answer Marie, No it would not be necessary to replace the case brake assembly as it is there to put water into the unit but the dishes will still get clean without contamination. Read More...
Steve March 07, 2017 for Model Number DW7933LRABB/AA I was told by a repairman to replace the Case Brake. Do I also need to replace the sensor? I am getting hte same HEAVY and AUTO blinkning lights.
1 Answer Hello Steve. If you need the case sensor DD94-01006A then you will need to order it as well. For the issue your having, it is usually the sensor causing it. Read More...
Jim September 22, 2016 for Model Number DMT800RHS/XAA For the brake case AP5176865 - which port does the OUT/DRAIN line go on? The two ports are identical and I forgot to mark which one is OUT. Thanks!!!!
1 Answer Jim, On the drain out the inner of the 2 will be the in and the outer is the discharge. Read More...
Vince April 29, 2016 for Model Number DW7933LRABB/AA I have to put a new brake in my washer. How do I remove to ring at the inlet in the tub to be able to remove the old one? Thank you
1 Answer Vince, The inlet ring inside the dishwasher is a twist lock ring and you would just need to turn it to remove. Read More...
Larry August 07, 2015 for Model Number DMT800RHS/XAA What does the Assy-case break #AP5176865 do? Would it affect the starting of the wash cycle? The unit fills with water but the wash cycle does not start. I can force it to pump out.
1 Answer Hello Larry, Since there are electrical components in this assembly DD94-01005A that provides an electronic impulse to the controller concerning the inlet of supply water, this part can be the cause of the issue. Read More...
Joe June 21, 2015 for Model Number DMT800RHS/XAA Part # AP5176865 Assy-Case Break I removed the Case Break and did not mark the drain hose IN & OUT as I should have. Could you advise which hose goes to which fitting on the Case Break ?
1 Answer Joe, The hose that goes on the left side will be held on the backside by a hose holder. This would be the longer of the 2 hoses and the shorter hose will go to the right side. Read More...