Gmorris August 30, 2023 for Model Number RF4287HARSXAA RF4287HARSXAA The auger motor doesn't stop/continue to dispense ice. I removed front DA97-08518D and checked the micro switch on the assembly with a meter and then the ice dispenser door micro switch it's ok. the only way to stop is to disconnect the wire connector in the side panel..
1 Answer Gmorris, based on the information provided, the main control has failed and is continuously sending voltage to the auger motor. The main control used would be dependent on the REV number of your appliance. If it is 00, the control would be DA41-00684A. If the REV is 01 or higher, the control DA92-00233D would be used. Read More...
John S October 23, 2016 for Model Number RF4287HARS,XAA Water dispenser is not working. I tried replacing the water inlet selenoid unit (DA97-07827B) and that didn't help. Now I'm wondering about replacing the dispenser part. should I use DA97-08519A (Assy lever dispenser) or DA97-08518D ( Assy cover dispenser? thanks for any help
1 Answer John, The dispenser cover assembly will be the most likely part that you will want to change out for this issue. Read More...
Larry August 10, 2015 for Model Number RF4287HAPN/XAA-0001 Segments of the temperature displays are not illuminating and others stay dimly lit. Would replacing Part Number AP5176331 solve this issue? Thanks, Larry
1 Answer Hello Larry. It sounds like you will need to order DA97-08679J to repair the unit. Read More...
Jim P January 16, 2015 for Model Number RF4287HARS/XAA-0001 How to remove the lever assembly from main assembly on touch pad assembly?
1 Answer Hello Jim. You will need to remove the assembly. To remove the dispenser cover you will need to remove the screw under the display cover. Then remove the display cover by pushing it to the right side and pulling it up. Disengage the housing connect of the display cover. Once removed, the levers unsnap from the assembly. Read More...
Bob August 09, 2014 for Model Number RF4287HARS/XAA I am trying to replace the Dispenser Front Assembly pt # DA97-08518D. I have tried to release the tabs with no luck . I can't tell if there is 1 tab on each side in the middle and 1 tab at the top or 2 tabs on each side near the bottom and top ? HELP Thanks Bob
1 Answer Hello Bob. You start at the bottom corners and work your way around releasing the tabs. Read More...
Joeamaco July 26, 2014 for Model Number Samsung rf4287hars/xaa There seems to be no space on the sides of this part -DA97-08518D in order to slide in a putty knife to disengage the holding tabs. How do I get this part out and replace the dispenser lever assembly part number DA97-08519A?
1 Answer Joeamaco, First thing to do is make sure that there is not a screw in the bottom of the part. If there is a screw then remove it and grab the cover assembly in the opening where the ice come out and give a good jerk. This should allow the cover to be released. Read More...