Julie July 25, 2017 for Model Number Samsung WF448AAP/XXA No draining error. Pump has been replaced and still same issue. Will go into drain and spin cycle if I partially drain manually. All of the drain lines have been checked for blockage. Nothing to find. My next thought is the PCB assembly, as I read this as a solution to the same exact problem another person was having. My big question is...before I order the part, this is what my PCB assembly has for a number on it: 20090119 G 0254 00133A-4C58 Now the only number on this that correlates with any of the PCB replacement parts is the 00133A.... So back to my question....what is the difference between 00133A and 00133B and 00133V, etc. as I look at them they all look identical, but not in price. Naturally the one I think i need, that ends in A is the most expensive one. My biggest concern is just that I order the correct part. And honestly I'm getting more and more confused as I search online for help with this. Thanks.
1 Answer Julie, The most likely difference would be the connection of the drain pump and you will want to use what the original part number is which would be DC92-00133A. Read More...
Tim August 10, 2015 for Model Number WF448AAW/XAA Error mesaage comes up about every other wash cycle. ERROR temperature sensor problem. thats the exact message. usually shows up during the rinse cycle. replaced the thermistor. still have the error.....not every cycle though
1 Answer Hello Tim. If the thermistor is new, you will need to check the wiring harness. If it is good, replace the control board. Read More...
David E. November 30, 2014 for Model Number wf448aapxac Will this part work with this model number, wf448aapxac?
1 Answer Hello David! Yes, the main pcb part number DC92-00133A is the correct replacement listed for your model. Thanks. Read More...
Michael February 18, 2013 for Model Number WF448AAP I had a service repair man come out and state I need a new PCB Main board. I am having issues with unit not draining, which is an intermittent problem that is getting worse. Is it easy to replace this board? Is it just unplug old one and put new in in? Is there any programming or initializing that must be done? Thanks.. Michael
1 Answer Hello Michael, Yes the installation is just unplug one and plug the other in. There is no programming involved. You may also want to check the drain for not being clogged as this is one of the most common drain problems. Read More...
Ken February 02, 2013 for Model Number wf448aaw Samsung clothes washer I get error message that filter is clogged, and machine won't drain. I pulled drain motor after clearing filter, and all tubes, and it ohms at 13.6, and runs great on bench test. I replaced both contol panels and got same error. I replaced water level pressure sensor switch, same error. What else is there to check. Once every 7 ot 8 cycles the drain pump will come on and work.
1 Answer Hello Ken, You will want to check to see if the pump is getting power when the unit calls or drain. If not then you will need to check the wiring and check for power at the control board for the drain. If power at control but not at drain then wiring issue. If power at control and at drain then need to replace drain pump. If no power at control board then replace board. Read More...
Ed August 27, 2012 for Model Number WF448AAW/XAA MY washer is not working at all tested power coming in to filter, it was good. Tested going out it was good so I figured it had to be control panel or control board.
1 Answer Hello Ed. Based on the information you provided, if there is power to the control board, but it is dead, you will need to order and replace the board on the unit. Read More...