Judith November 10, 2018 for Model Number wa45h7000aw samsung top load My washer will stop with 18 minutes left. It has the spin and rinse cycles to finish. There is no error message. If I unplug the washer for more than 20 minutes it works fine on a cycle no longer than 60 minutes. Contacted a repair man. His opinion was the control board is overheating and we would not be able to purchase a new control board a Samsung machine. This machine was purchased on November 9, 2016 so it is only 2 years old. Any suggestions as to how to proceed . Thank you for your assistance.
1 Answer Judith, The control board would be the main board which is part number DC92-01625B. Read More...
Chris August 11, 2017 for Model Number WA48H7400AW/A2 Samsung top load washer, approx. three years old according to serial number. when washer is almost done with spin cycle, 3 to 9 minutes left, it resets to 22 minutes, fills the washer back up, then goes back through a spin cycle. Usually at the end of this 22 to 23 minute cycle it trips a UB error code and beeps profusely, shutting off leaving my load still wet. I changed out the suspension rods, though mine looked fine. First load worked perfectly fine. second load same thing, filled back up tripped UB, beeped, everything still wet! I did unplug to replace the suspension rods. Any further guidence?
1 Answer Hello Chris. If all rods are new, you will need to make sure the unit is level and the pulsator and basket are tight. If so, you will need to replace the control board. Read More...