Ben B. January 31, 2016 for Model Number Dacor PGR30S I need to replace the over igniter in my Dacor PGR30S range. I have the kick panel off, and see the base of the igniter, but I cannot figure out how to remove the panel on the floor of the oven to access the ignitor. Can you help?
1 Answer Ben, There are 6 screws in the oven bottom that will need to be removed. Once removed you will lift the oven bottom off and remove the shield under it. Once this is removed you will have access to the igniter. Read More...
Gordon July 19, 2015 Hi there, I have just ordered a replacement Ignitor (82473) for my Dacor ERD 36 Range. Do I have to open up the back of the range to change or can I do it all from inside the oven? Thanks, Gordon
1 Answer Gordon, If you take the racks and the floor of the unit out you should be able to access the igniter to be able to change it. Read More...
Curling3 July 17, 2015 for Model Number ERD36 Need to replace igniter part 82473. Do I need to get into back of range to replace.? thanks.
1 Answer Curling, You should be able to access the igniter from inside the unit without pulling it out. You would just need to cut the wires and splice them together. Read More...
Becky July 21, 2014 for Model Number ERD48 Will I be able to access the igniter wiring from the inside of the oven, or will the range need to be moved out from the wall to replace the igniter? Thank you
1 Answer Becky, If you take the racks and the floor of the unit out you should be able to access the igniter to change it out. Read More...
Ben S. November 24, 2013 for Model Number PGR30 Dacor Oven Range I just ordered a Hot surface Ignitor for my Dacor Range Oven. I'm not sure which wire is Hot or Negative? How can I tell which one to attach it to? Purchase order # 76996692, Part # 82473
1 Answer Hello Ben, You don't have to worry about which wire goes where because this is not a polarized part. Read More...
1 Answer Frank, Yes you can cut and reattach the igniters with wire nuts. Make sure you use Hi Temp, Porcelain, wire nuts DE81-08428A and route the wires properly. Thanks and Good Luck Read More...
Bpmcook September 26, 2011 for Model Number ERD48 What is the best way to access the connectors for the Hot Surface Ignitor? Thanks
1 Answer AP3393105Hi BPMcook. It Is best to get into the front lower area. Remove the door. Remove power. Remove the oven racks. Remove oven burner assy. and unhook electrical lead. Unbolt igniter and replace it with part # DE81-07046A. Thank you. Read More...