John November 29, 2018 for Model Number ECD230SCH Halogen Light Transformer on Dacor Wall Oven has failed. Replacement parts 62808 or 62724 do not show to be available. Any alternative transformers available? Thanks
1 Answer John, Unfortunately, this part is no longer available and no satisfactory replacement has been provided by the manufacturer. Read More...
Monty G October 25, 2016 for Model Number Dacor double wall oven ECS 230 SCH The light bulbs in upper oven need replacement, what volt/watt? Do I need to buy? Thank-you.
1 Answer Monty, The light bulb for your unit will be part number DE81-05142A which is a 10 watt 12 vac bulb. Read More...
Eric H. August 29, 2012 for Model Number Dacor Double Oven MCD 227S What does the code "22" mean on my oven screen. The only thing that works is the lights. I already changed the transformer.
1 Answer Hello Eric, First you'll need to reset the error code before you can use the oven again. To do this you need to enter the Diagnostic mode. To Enter the Diagnostic Mode: With the main power supply to the oven turned on, press and hold the CANCEL/SECURE and # XXXXX at the same time. When the diagnostic password XXXXX appears, release the CANCEL/SECURE key first then the # XXXXX. Press the 7 key on the keypad repeatedly until the letter “S” appears just below the words SERVICE ID NUMBER. Wait 3 seconds. Enter your Dacor Servicer Number. Press ENTER. I think the code is S1234. Then click error codes on the right option and reset the error. Now as for the U22 error, if the error comes back then you have a problem. This can be caused by either a bad oven sensor or a bad display relay control board. You can't test the board but you can test the sensor. Open the door and remove the 3-4" long thin metal rod attached to the back wall. There are 2 screws holding the sensor on that you can remove and then pull the sensor forward until you can disconnect it. With a multi-meter, check the resistance of the sensor at room temperature and it should be about 1080 ohms. If it's not, replace the sensor, otherwise you need to replace your relay board. Read More...