Allen August 23, 2016 Regarding 38174 Goodyear Washing Machine Belt dimension. Width is 1/2 inch Length is 28 3/4 inch. Is the length measured from the inside or outside?
Hailey August 28, 2015 for Model Number LWD70AW HI! Would it be possible to have some instructions as to how to change the drive belt (and I believe it would be part 27001006, correct?) on my washing machine (Amana LWD70AW)? Thank you!
1 Answer Hello Hailey. To install the belt you will need to remove the two springs in the front and remove the motor and pump assembly from the washer. Now you need to remove the pump from the motor and install the belt onto the motor pulley. Once the belt is installed, you will install the motor and pump back into the washer and then roll the belt onto the large pulley. Make sure the idler arm is applying tension to the belt when you roll it onto the large pulley. Read More...
Kent November 29, 2014 for Model Number ALW880QAW I did not receive instructions with the belt on how to install.
1 Answer Hello Kent. To replace the belt WP27001006 on the unit, you will need to remove the two springs in the front and remove the motor and pump assembly from the washer. Now you need to remove the pump from the motor and install the belt onto the motor pulley. Once the belt is installed, you will install the motor and pump back into the washer and then roll the belt onto the large pulley. Make sure the idler arm is applying tension to the belt when you roll it onto the large pulley. Read More...
Chuck September 02, 2014 for Model Number ALW880QAW Do I need to (or should I) replace the idler wheel and idler spring, while I am replacing the drive belt?
1 Answer Hello Chuck! No, you should not have to replace the parts unless defective now. Thanks. Read More...
Homey February 23, 2014 for Model Number maytag washer sav405deww How to change the belt for this washer?
1 Answer Hello Susan. To replace the belt 27001006 on the unit, you will need to remove the two springs in the front and remove the motor and pump assembly from the washer. Now you need to remove the pump from the motor and install the belt onto the motor pulley. Once the belt is installed, you will install the motor and pump back into the washer and then roll the belt onto the large pulley. Make sure the idler arm is applying tension to the belt when you roll it onto the large pulley Read More...
Rich June 03, 2013 for Model Number sav4655eww How do I replace the drive belt on this Maytag sav4655eww washer? Do I have to pull the motor or just drop the pump? TY
1 Answer Hello Rich, The motor on this unit has to be pulled to access the screws which hold the pump to the motor. Mark the pump to indicate which pump leg the belt wraps around to avoid issues and frustration. be careful also not to stretch the idler spring. Read More...
Lloyd R. June 25, 2012 for Model Number SWT910WN1124 what size bely is this? this is a top load speedqueen washer. Belt has numbers as 38174 goodyear belt.
1 Answer Hello Lloyd! The agitate belt 38174 is 28 3/4" in length and 1/2" in width. Searching your model SWT910WN1124, this is the correct replacement drive belt for your product. Thanks! Read More...
Sandy June 20, 2012 for Model Number NAV5800Aww amana How do I tighten a loose belt on my clothes washer?
1 Answer Hello Sandy. The belt is suppose to be a little loose, but if it is to loose, you will need to replace the drive belt WP27001006. Read More...