William N May 31, 2017 for Model Number DA68-01661B Where can I purchase a set screw for the handle on a Samsung refrigerator freezer draw?
1 Answer Hello William. We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Barbara November 11, 2015 for Model Number Jenn Air wall oven WM277W When turning oven on, setting the temperature the oven will go to 140 degrees and go to On and will try to heat for about 40 seconds and goes off. Broil was not working either. Repairman tapped the upper right hand of oven door and it started heating in Broil position. Now it is doing nothing.
1 Answer Hello Barbara. Check for some bad wiring. If none is found, you most likely have a bad control board. This part has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
Murray November 28, 2013 for Model Number rf263afbp customers Samsung bottom mount fridge , French doors,twin cool, freezer works fine , fridge evaporator around fan frozen with ice, installed new evaporator with fan cover assembly , cleared drain trough, installed new defrost terminator, and temperature sensor, installed new control board , temperature stays too warm in fridge , came back and removed evaporator cover ,everything looks clean , good frost pattern on evaporator coil, but fan does not come on, all the connection plugs for fan and thermosat and sensor are firm, does the sensor have to be relocated? thanks
1 Answer Murray, The sensor would not need to be relocated and needs to be where the manufacturer had it installed. You will want to see if the unit is getting power from the control board to the fan. Should be 12vdc to the fan motor. Read More...
Diana Reyes October 13, 2012 for Model Number AP4261179 What size is the screw head and/or what craftsman hand tool do I need to remove?
Dmb December 12, 2011 for Model Number LER5636EQ3 Is this the screw needed to screw heating element housing back into place?
1 Answer Hello DMB, Yes, based on the model number, WP90767 is the correct heater housing screw. Hope this helps. Read More...
Dorothy June 18, 2011 for Model Number MDE8000AYW This screw is shown on the diagram with the timer knob. Does it hold the knob on or what is its function? I can't find it on my timer knob. Thanks.
1 Answer Hello Dorothy! The screw WP90767 is the timer screw. This holds the timer WP33001730 down in place. Thanks! Read More...