Chuck S March 18, 2018 for Model Number JFC2089HES The left door often fails to close fully, unless we give it a bit more of a push than we formerly had to. I figure it's either the bushing (14 on the parts diagram), or friction in the hinges of the vertical mullion door guide (10 on the parts diagram). There's no visibly evident damage to the door guide or to the pivot block (13 on the parts diagram).
1 Answer Chuck, For this issue check to make sure that the mullion is going into the guide properly at the top of the cabinet. The bushing will most likely not cause this issue but would be more likely in the mullion or the guide assembly. Read More...
Mike May 13, 2015 for Model Number KBFA25ERSS00 I am having a problem with the left door not closing. I have to lift up the door to close it. Could this be a bad bushing?
1 Answer Hello Mike, This would be a door closure WP67003639 issue. The door will have to be emptied and removed from the unit to replace this part. Read More...
Paul January 10, 2013 for Model Number maytag mfd2561hes Left door rattles, when I lift a little the rattle stops. My thought is that it is a bushing.
1 Answer Hello Paul. If the bushing is bad, you will need to order and replace part number WP67002721. Read More...
Greg August 11, 2012 for Model Number afd2535des This part doesn't show on the diagram. Is it for the bottom, left door hinge? Is this the only plastic part there? So there is no shim needed? Our black plastic part broke, so it is not the door sagging or etc. Thanks.
1 Answer Hello Greg! The door bushing WP67002721 is on the top of the diagram listed as item 12- it is part of the left door top hinge portion. I believe the black plastic part you are looking for is the door closure, part number WP67003639. Thanks! Read More...
John December 14, 2011 for Model Number #59676523500 Will a new bushing keep the right door closed? The door keeps popping open when the left door is closed. Is there another part I need to order. I cannot find any information on this problem without paying $50....if I'm going to pay that, why not just call service?
1 Answer Hello John. You will need to check and see if the door closure WP67003639 is bad on the unit. If so, it can cause the problems you are having. Hope this helps. Read More...