Lou D. May 19, 2017 for Model Number ARSE66MBW Please disregard my previous message.I received the chute door which I ordered and I now see what the assembly of the three parts look like. I would appreciate some instructions on how I go about installing the part onto the hinge plate. Thanks
1 Answer Hello Lou, The spring will slide onto the end of the ice chute hinge and the retainers hold it in position after the spring is rotated to give tension in the closing position. I'm sorry but the manufacturer has no printed instructions on the installation and the service guide does not cover this repair. Thank you for your patience and understanding in this matter. Read More...
Lou D. May 18, 2017 for Model Number ARSE66MBW My Amana ref. was purchased in 2002.I have ordered a new chute door (#111) on your drawing.The chute door broke loose from the hinge plate.the plastic projections which fit into the holes in the hinge plate broke off.Your drawing shows two other parts,a Seal #171 and an Insulation #91, which do not exist on my refrigerator.Please enlighten me.Have I been missing some parts for the last 15 years?Thank 's for your help.
1 Answer Hello Lou. Your flap is already put together as an assembly with the foam and seal. Read More...
Don October 19, 2015 for Model Number 59651672100 Is it possible to install a new door chute on the ice dispenser without removing the outside panel . If not how do you remove the parts to get to the area that you can replace the door chute to the ice dispencer?
1 Answer Hello Don. Yes, if you can reach inside to the lever, you can snap the chute in place without disassembling the dispenser. Read More...
Roger May 25, 2015 for Model Number 59651672100 I have a Kenmore refrigerator that has a broken part that the ice chute cover attaches to. It is part #7 in the blow up diagram but I can't find it in the parts lists anywhere. Do you know what number I would need to order to get the right one for it? It also hooks onto the plunger of the solenoid if that helps. Any help you could offer would be appreciated. thanks
1 Answer Roger, The part that you are looking for would be the ice extension chute hinge kit part number 12002464. Read More...
Wanda November 21, 2014 for Model Number MSD2641KEU Installed flap on ice chute still doesn't close completely
1 Answer Hello Wanda. It sounds like the solenoid 67006000 is bad and will need to be replaced on the unit. Read More...
Mike D July 30, 2012 for Model Number MSD2351HEQ My ice chute door has something like algae growing on it, how can I remove the chute door and clean it? Thank you!
1 Answer Mike, You'll need to dismantle the dispenser assembly. We'll send you some information that should help. But be carful, and make sure you remove power to the dispenser, and or refrigerator before you start. Thanks Read More...