Customer Questions and Answers for Ice Enclosure by Whirlpool

Marshall, there are going to be four mounting screws in the front where the auger arm is that would need to be removed once the auger arm is unscrewed from the auger shaft. Once this is done, the auger can be transferred to the new shelf.

Hello Guitarman, If the icemaker is overfilling, replace the water valve. However, if the icemaker is leaking, just replace the icemaker.

Jeff, Yes this ice bin enclosure 61005614 will be the replacement enclosure for your unit.

Hello Lary. The best test if to perform a power test to the auger motor in the unit. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html

Hello Richard. No, 61003335 has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part.

Fran, If you are referring to the wiring of the auger motor, there are 2 wires and you can place them on either one of the terminals as it will not cause any issues.

Hello Larry, The water dripping is either from low water pressure to the unit or a bad water inlet valve 12001892 or 61005626, (both should be replaced at the same time as per the manufacturer). 61005614 is the part where the auger motor mounts.

Hello Dave, If you need only the ice bin, you will need part number 61004802. I'm sorry but this part has been discontinued by the manufacturer and no satisfactory substitutions have been provided. You might be able to locate one online or at a local dealership if you can find one that has the part in stock.

Hello Jack, The ice bin is no longer available as a complete assembly, so we need to know what part/s are broken to provide you with part numbers and the procedure. The ice door kit will be part number 12001991.

Brad, Yes, the ice enclosure part number 61005614 is the correct part for your unit.