Fred E February 27, 2017 for Model Number WTW7800XW2 This is the third time i have replaced the lid on this machine. Is the design that poor or is there something that can be done to stop the the lid from being pushed back where it breaks the plastic part of the hinge assembly.
1 Answer Fred, There has been no change in the way that the lid has been designed. The one thing that you will want to make sure of is to make sure that the lid is not being pushed on. Read More...
Dan May 09, 2016 for Model Number wtw7800xw2, serial # c11270358 The glass lid is separating from the stainless/metal rear part and the glass part. Is this the hinge that needs to be replaced? Surely they did not make this so cheap that it breaks apart and the whole lid will have to be replaced?
1 Answer Hello Dan. Yes, you will need to replace the lid WPW10349136 to repair the unit. Read More...
Jimmy December 15, 2013 for Model Number WTW7800XW2 The lid hinge in back right corner is cracked. This allow the glass to bow upward. Do I need the hold lid and tell me what I need to do? Thanks
1 Answer Jimmy, For the issue that you are having you would need to replace the lid assembly. In order to replace the lid, you would open the lid and on either side there are 2 screws. Remove the screws which will release the hinge and lift off. Install new lid and screws. Read More...
1 Answer Hi. Raise the lid and remove the two hinge pin screws from both sides of the lid. Lift the lid and slide it off the hinge pins, removing the lid from the washer. Replace the lid part # WPW10349136 in reverse steps. Thank You. Read More...
Keri May 29, 2012 for Model Number WTW7800XL I think I've found the right lid, a floating tempered glass lid, but which item # is for Lunar Silver?
1 Answer Hi Keri. We had to use the model # WTW7800XL(2) because the last # was not given. It brings up silver lid part # WPW10349136. Thank You. Read More...