William B March 15, 2013 for Model Number LSG7806AAM I ordered a new motor that has the new harness style wiring box. The instructions are clear how to rewire except it leaves out a blue and white wire from the old motor plug that goes into the blue dot coded terminal from old motor switch, where do I connect those?
1 Answer William, The white will go to the thermal protector tab and the blue will go to terminal 5. Read More...
Ahron O. January 17, 2012 for Model Number LSG7806AAE I purchased dryer motor part # 306055 for my dryer. The old motor has color coded wires; yellow to yellow , black to black, red to red, gray to gray and blue to blue. The new motor has no color on it at all, only numbers. What number does the yellow wire go to? what number is for the black wire red wire gray wire and blue wire?
1 Answer Hello Ahron! Please see the following link to our free repair forum. This will have instructions that will help you install your new motor part number W10411000. Thanks! http://forum.appliancepartspros.com/dryer-repair/327049-wiring-dryer-motor.html Read More...
Bruce E. October 05, 2011 for Model Number LSG7804AAE MY APPLIANCE REPAIR SERVICE ATTEMPTED TO INSTALL A NEW DRYER MOTOR(PART NO. 306055) AND TOLD ME THE NEW MOTOR HAD A QUICK CONNECT ADAPTER AND HE DID NOT KNOW IF IT COULD BE USED TO REPLACE THE OLD MOTOR, WHICH DID NOT HAVE A QUICK CONNECT FEATURE. ARE SPECS OR INSTRUCTIONS AVAILABE ON HOW TO DO THIS? AVAILABLE.REPAIR SERVICE IS RESEARCHING BUT IT TAKING WAY TO LONG.
1 Answer Hello Bruce. The motor W10411000 does not use a quick connect. They will need to match the number and wires off the old motor onto the new motor. This is not hard to do, as the numbers should match up the correct wiring. Hope this helps. Read More...
Art H. September 20, 2011 for Model Number SE1000 Maytag stacked washer-dryer I purchased a new mtr part# 306055 of which the wiring switch does not have the same markings as the old mtr. I have 4 wires red,blk,blu,grey which need to go on the new mtr switch. The new mtr switch has terminals marked 2,6,4,3,5,1 and grd. The old switch was marked with the colors of the wires. Which colored wire goes on which number of the new switch?
1 Answer Hello Art. The best way to do this is to compare the terminals color makrings on the old switch to the new switch numbers W10411000. Hook the wires up to the new switch in the same order they were on the old switch. Hope this helps. Read More...
1 Answer Hello Kay, the motor is mounted at the bottom of the dryer near the left rear of the unit. Thanks! Read More...
1 Answer Hello George! Here are the instructions from the manufacturer, hope it helps! 1. Remove screw securing blower to front base frame bracket. 2. Remove two screws at front corners of motor bracket. 3. Remove wires from thermostat and thermistor. Remove dryer wire harness wires from motor switch. Do not disconnect the wires that come out of the motor, from the motor switch. NOTE: There is no wire on the yellow motor terminal. 4. Lift up slightly and pull motor and blower assembly out the front of the dryer. NOTE: The two tabs on the motor bracket fit in slots on the motor base platform. 5. Place motor and blower assembly on protected surface to continue any other disassembly. Read More...