Judy November 15, 2019 for Model Number MEW6527DDB I received RP 5765M440-60, OEM 74008773 instead of RP 5765M483-60, OEM 74008769. Can that control panel be used?
1 Answer Hello Judy, These two control panels do cross so you should be able to use that control panel in place of the other without a problem. Read More...
John S September 14, 2017 for Model Number MEW6527DDS Some oven buttons aren't working. Replaced part #W10757357 already and that did not fix the issue. Which part is the replacement for the ribbon cable?
John August 09, 2016 for Model Number MEW6527DDS Maytag wall oven model mew6527dds. Control panel went dead during a brownout. Checked power ok to unit.
1 Answer Hello John. You will need to order and replace the control board W10757357 if there is power coming to it and it does not work. Read More...
Mike R June 28, 2016 for Model Number Maytag MEW652DDB Over two days the oven keypad stopped working. First the bake button followed by all the others within 24 hours. How do i tell if the keypad is bad or if it is the control module? The cancel button still works :) tks Mike
Jean June 05, 2016 for Model Number MEW6527DDS Maytag Builtin Electric Wall Oven The buttons on my wall oven do not all operate. The bake button does not but the convection bake does. Some of the number buttons do work. The timer and clock buttons do work. What parts do I need to fix this and can you supply repair instructions? Thank you, Jean
1 Answer Hello Jean. You will need to replace the control panel 5765M483-60 on the unit. Read More...
Wallie January 29, 2014 for Model Number MEW6527DDW When pushed bake button want work I have to use covect bake button and on the number pad #2 want work and also the oven light button is the same. Do you think I need a new panel contol?
1 Answer Hello Wallie. Yes, based on the information you provided, it sounds like the control panel needs to be replaced on the unit. Read More...
Martin J. February 06, 2012 for Model Number mew6527dds How do I install part #AP 4416969? Any special tools needed? Any speical skills needed? Where are the screws location to disconnect the part? I do not see them. Do i pry off of the cover? Help Please
1 Answer Hello Martin. 1. Turn off power to unit. 2. Remove screws securing trim piece(s) to the cabinet. 3. Slide unit out of cutout approximately 6 to 8 inches. 4. Remove screws securing control panel assembly to unit chassis. 5. Label and disconnect wire terminal plugs from control board assembly. 6. Place control panel 5765M483-60 assembly on a protected surface. 7. Reverse procedure to reassemble. Hope this helps. Read More...