Customer Questions and Answers for Shipping Bolt Kit by Whirlpool

Hello Matt. The model number you provided, is a dryer, and does not use shipping bolts.

Hello Will. No, there are no shipping bolts for the dryer.

Hello Miguel, The only time you need these W10289554A is when you are going to move the unit. They hold the insides steady so there is no damage incurred to the unit during transit.

Tony, you will need to order part number W10289554A for the shipping bolts on model GHW9400PL4. This is a kit and contains all four shipping bolts. Thanks!

Michael, the appliances do not need shipping bolts for transportation. Here are the use and care manuals to your appliances. The washer you will need to refer to page 19 and the dryer you will need to refer to page 20, this will take you to the transportation section of the manual. Thanks! Washer Manual: https://www.whirlpool.com/digitalassets/MLPDF/Use%20and%20Care%20Guide%20-%20W10113000.pdf Dryer Manual: https://www.whirlpool.com/digitalassets/MLPDF/Use%20and%20Care%20Guide%20-%20W10150626A.pdf

Hello Phil! The manufacture does not require shipping bolts for your model MAH6500AWW. Make sure the washer is transported upright and not on its side. You can also place a large comforter inside the unit and underneath the unit to help maintain balance of the drum. Hope this information helps you, thanks!

Jill, On your model, front load washer MAH5500BWW , there are no replacement shipping bolts. If you are going to relocate the washer, after the original installation the manufacturer recconeds: "It is important to drain and remove the inlet hoses from the washer. Lower the drain hose to a floor drain to allow water inside the washer to drain out. Then snap the drain hose vertically to the back of the washer. Open the door to the washer. Taking a blanket, roll the blanket lengthwise and tuck the blanket into the recessed boot arae around the perimeter of the door opening. This will suspend the outer tub assembly and limit it's movement during transit. Shut the door and tape it shut. Upon arrival at the new location, remove the tape, open the door and remove the blanket. Then follow the normal installation procedures as outlined in the installation manual." Good Luck and Thanks

Marge, You will need four bolts W10289554A and heres some more information " There are 4 bolts in the rear panel of the washer that support the suspension system during transportation. These bolts also retain the power cord inside the washer until the bolts are removed.Using a 13 mm wrench, loosen each of the bolts. Once the bolt is loose, move it to the center of the hole and completely pull out the bolt, including the plastic spacer covering the bolt. Once all 4 bolts are removed, Then pull the power cord through the opening of the rear panel and close the hole with the attached cap." Thanks and Good Luck

Hello Jim! The shipping bolt W10289554A comes as a set of four. It has two upper and two lower shipping bolts. Thanks.

Hello Mike! The shipping bolts are not universal. We will need your appliance model number. Thanks!