Steve August 01, 2022 for Model Number KBFS20ECMS00 IT DIDN'T USED TO DO THIS, BUT MY REFRIGERTAOR DOOR NOW OPENS VERY WIDE AND HITS MY KITCHEN WINDOW. IS THIS BECAUSE OF A BROKEN PART NUMBER WP67007011? I WANT TO STOP THE SWING OF THE DOOR AT ABOUT 130 DEGREES.
1 Answer Steve, If your door stop is black then yes that is the part number you will want to replace. W11708403 Read More...
Helen November 20, 2020 for Model Number WRB322DMBB00 The refrigerator was just delivered and installed. The door swings too far open and hits the table on the right side. There is no stopper. What stopper should I add?
Bill May 14, 2020 for Model Number MFI2665XEB0 Our refrigerator right door when it closes by itself does not close tight. We have to push it tight. Is there a part on the door that may have gone bad? We had another refrigerator that had a part that made the door close tight. When we close it tight it does seal tight. Any ideas? Thanks
1 Answer Hello, Bill. Inspect the door gasket and if the gasket is not the problem, replace the door closure p/n AP6010369. You can watch the video attached to the part on our site to assist you with the project. Thank you. Read More...
Mary August 19, 2015 for Model Number Maytag MBF1953DEM This refrigerator is in a position to hit my kitchen cabinets when the door swings open. The door is open more than 180 degrees when this happens. Does this model have an adjustment that I can make to prevent it from going past 180 degrees?
Dawn L May 05, 2014 for Model Number kenmore model 59666253401 I purchased stop door part nbr 67003780. I had door reversed but door keeps slamming the side to fridge. I now have the part but no instructions to install it. would you please email me instructions on how to replace this part. thank youi
1 Answer Dawn, There are no instructions available on how to install the door stop. To install you will need to remove the upper hinge cover and hinge. Remove the door from the bottom hinge and turn the door upside down. This will allow you to be able to install the door stop. Read More...
Earnest September 05, 2013 for Model Number KFIS20XVMS00 Just completed a kitchen remodel and due to a miscalculation when the walls were reframed and cabinets installed, the R/H door handle contacts the front edge of the granite countertop before it reaches the fully open position. Cabinets situated in an "L" configuration with refer on the short end. The cabinet to the right of the fridge was supposed to be 12" but ended up being 8" so the door hits the face of the return countertop. Question is is there any part availiable that i can install to limit the full open range of the door or any adjustments that can be made to prevent the door from opening all the way? Thank you, Earnest
1 Answer Earnest, Unfortunately there is no type of device that will allow the door to not open fully. Read More...
Tom January 31, 2013 for Model Number gb2fhdxwq05 How to stop refrigerator door from opening to far and banging the wall?
1 Answer Hello Tom, If the door was reversed you will want to make sure that the door stop was switch over to the hinge side of door. If the door stop is missing then you would need part number W11708403. Read More...
1 Answer Hello Jim, I would check the door closure WP67003639 and door stop W11708403. Hope this helps! Read More...