Customer Questions and Answers for Compressor Start Device by Whirlpool

Michael N, Using a multimeter it would be recommended you check to see if there is power to the start device when it should be coming on and if not check the wiring back to the control and the power out of the control.

Hello Marc, if you put your hand on the warm compressor and it is slightly vibrating, check the evap coils for frost build-up, if little to no frost then there is a sealed system problem , usually a freon leak. You would need a service technician to check further.

Mathen, if the model number of your appliance could be provided in a new inquiry, this will allow for the most accurate information to be presented.

Hello Minh, first, check the wire harness connection at the top left side fresh food door hinge by removing the hinge cover. If the wires are ok then replace the rear main contorl board WPW10312695, after the board is installed it will need to be coded with the version number located on the model/serial tag. The Technical data sheet that came with your ref has the coding steps , the sheet is usually located under/behind the lower front grill.

Lorenzo, A icemaker works off of temperature. It needs to be about zero degrees for the icemaker to cycle. If the temperature is too warm, you either have a sealed system or air flow problem.