1 Answer Gary, the screens on valve 285805 are not available separate. You will have to order a new valve. However, you can clean the screens by taking off the hoses, pop out the screens and soak them in a small amount of white vinegar and hot water. Hope this helps! Read More...
1 Answer Hello, You should be fine with this. The difference is only 2 watts. Whirlpool made this valve to work with several different washers. Hope this helps. Read More...
Shawn W March 01, 2011 Whirlpool washer continues to drip water into tub after cycle is complete. If clothes aren't immediately removed after cycle, they are soaked again in a few hours. Would it be my water inlet valve??? Or some washers worn out?
1 Answer It seems like you have a bad water inlet valve 285805, I would replace that first. Read More...
1 Answer The valve that allows cold water in could be faulty and will not open to allow the unit to fill. To find the correct water valve we would need a model number. Read More...
1 Answer Undo the hose on the faucet side and undo the hose on the valve side and pop out the screens. You can use a small amount of white vinegar and hot water to soak them clean. Read More...