Customer Questions and Answers for Tub Wheel Assembly by Whirlpool

Pete, Reinstalling the rear rack stops WPW10195622 is relatively easy, they snap and lock in place once you insert them into the track assembly. First place the rack stop with the two openings(holes) facing towards the center of the rack, into the end of the track, hold the track firmly and press in on the rack stop until you feel or hear the locking tabs set and lock into place on the track. Then install the rack, and the front rack stops in the same manner. Thanks,

Pete, The rear rack stop should just push into place and lock in. This would be the only way it will go in.

Hello Pete. Yes, you will need to pull the unit out to replace these.

Hello Diane. You will need to uninstall the dishwasher and pull it out of the cabinet just enough to access and remove the screws from the wheels.

Hello Fede. There is one in each package.

Hello John. Make sure the dispenser is good and clean. If so, you will need to order and replace the dispenser on the unit.

Don, You will need to pull the dishwasher out and once you have the unit out there will be screws on the outside of the dishwasher that will hold the wheel assembly in place.

Hello John. No, the screws are on the inside of the tub, not the outside of the tub. You will need to remove the upper rack and the rack track to replace the wheels.