Parts for Frigidaire CRA086HT10: 03 - Recommended Spare Parts

This air filter screens the air moving through your appliance's ventilation system, capturing odors and fine particles. Replacing a clogged or damaged filter helps maintain proper airflow so the unit vents and circulates air as designed. What it does:

• Captures odors and airborne particles as air passes through the unit
• Helps maintain proper airflow/venting performance
• Reduces debris buildup on internal components
• Common signs it's due: persistent odors, reduced airflow/venting, a visibly dirty or damaged filter

• 1 air filter

• Disconnect power and allow hot surfaces to cool before servicing
• Open the filter access panel or grille and note the filter's orientation
• Remove the old filter; seat the new filter fully and close the cover
• Restore power and verify proper airflow

This blower wheel circulates air through the dryer drum and venting system to maintain proper airflow for efficient drying. Replaces a worn or damaged wheel to help restore drying performance and reduce unusual noises. What it does:

• Channels air from the dryer motor through the drum and exhaust system
• Helps maintain consistent drum airflow for faster, more even drying
• Can reduce or stop rattling, scraping, or thumping noises caused by a broken or imbalanced wheel
• Restores proper vent pressure that can prevent extended dry cycles

• Disconnect power to the appliance before beginning any repair.
• Access usually requires removing the dryer front or rear panel; keep fasteners organized.
• Inspect the motor shaft, mounting clip, and housing for wear; replace damaged hardware as needed.

This lower front toe-kick grille replaces a damaged or missing lower front panel to restore the refrigerator's finished appearance and protect the venting area. It fits into the toe-kick opening and provides a clean, finished look. What it does

• Covers the refrigerator's lower front vent/condensing area for a finished appearance
• Helps keep debris and small objects out of the vent opening
• Replaces cracked, warped, or missing toe-kick panels that detract from the appliance's look
• Restores proper panel alignment and cosmetic appearance after damage

• Disconnect power or unplug the appliance before working near electrical components.
• Many installations use snap-in tabs or a few fasteners; remove the old grille and align tabs, then press or secure per the service manual.
• Use basic hand tools and follow the model-specific service instructions for safe removal and reinstallation.

This fastener kit supplies the assorted screws and clips used to secure panels and components on compatible Frigidaire appliances, helping restore proper fit and stop loose or rattling parts. Ideal for repairs where original mounting hardware is missing or damaged. What it does:

• Replaces worn, missing or damaged mounting hardware so panels, brackets and trim stay secure
• Helps eliminate vibration noise and loose-fitting parts that cause rattling
• Restores correct alignment for doors, panels or internal assemblies that use small fasteners
• Provides the specific fasteners needed for the factory-replacement process

• Basic hand tools (screwdrivers, nut drivers) are typically required; refer to your model's service manual for exact fastener locations and torque
• Turn off power and disconnect the appliance before starting any repair to avoid shock or injury
• Handle small parts carefully and keep them away from children and pets

This overload protector is a refrigerator compressor safety device that helps prevent compressor overheating and electrical overloads, protecting the cooling system and helping restore normal compressor operation when conditions allow. What it does:

• Interrupts compressor power if the compressor overheats or draws excessive current
• Helps stop compressor damage from thermal or electrical stress
• Commonly used when the compressor hums but won't start, or when the fridge cycles on/off rapidly
• Works with the compressor start/relay assembly to ensure safe start-up and operation

• One overload protector

• Disconnect power at the breaker or unplug the appliance before inspecting or replacing the part
• Handle compressor terminals and wiring carefully; avoid bending or stressing terminals
• Replace the start relay at the same time if recommended by diagnostics