Parts for Electrolux FFRL0633Q12: 02 - Recommended Spare Parts

This replacement remote control restores convenient handheld operation of your appliance, letting you change settings and control basic functions from a short distance without opening the unit. Easy swap for a failed or missing remote. What it does:

• Sends control commands to the appliance so you can change modes, power, and settings remotely
• Restores normal remote response when the original remote is lost, damaged, or unresponsive
• Helps diagnose whether issues are remote-related versus appliance-related by verifying signal/send function
• Works only with compatible appliance models that use this OEM remote protocol

• Insert fresh batteries and test remote operation before installation
• Follow the appliance manufacturer's pairing or setup procedure if required
• If remote still does not operate the appliance, check battery orientation and replace batteries, then refer to the appliance's user manual
• Dispose of used batteries properly and avoid exposing the remote to moisture or extreme heat

This temperature sensor (thermistor) monitors fresh food/freezer temperatures and sends readings to the refrigerator control board so the appliance maintains consistent cooling. Replaces a failed or intermittent sensor to restore accurate temperature control. What it does:

• Senses interior temperature and reports it to the control board
• Helps the compressor, fans and defrost system run at the correct times
• Common symptom: fridge or freezer temperatures are too warm or fluctuate
• Common symptom: unit runs constantly or cycles erratically
• Common symptom: inconsistent cooling between compartments

• One temperature sensor (thermistor)

• Disconnect power to the appliance before attempting any repairs
• Handle the sensor and wiring gently; avoid kinking or stretching the lead
• Verify connector pins align and seat fully; some models use a simple plug-in connector

This thermistor is the refrigerator temperature sensor that helps the control board monitor and regulate cooling. Replacing a failed thermistor restores accurate temperature readings for more consistent fridge and freezer performance. What it does:

• Senses internal air temperature and sends that information to the control board
• Helps the defrost and compressor cycles run at the correct times
• Commonly linked to symptoms like inconsistent temperatures, error codes, or a unit that runs constantly
• Does not control cooling directly but provides the temperature feedback the system needs

• Always disconnect power to the appliance before beginning service
• Typically located in the fresh food or freezer compartment near the evaporator
• Handle the sensor and wiring gently; avoid pulling on the wires or bending the probe sharply
• If troubleshooting, verify wiring and sensor resistance per the manufacturer's service instructions before replacement

This replacement platform provides a stable base inside the oven cavity to support the oven floor and related internal components, restoring proper alignment and preventing sagging or rattling. What it does

• Supports the oven floor and internal components to maintain correct alignment.
• Helps stop movement, vibration, or rattling coming from the oven cavity.
• Restores a flat, secure surface for heating elements and cookware.
• Useful when the original platform is bent, warped, or cracked, causing instability.

• One platform.

• Disconnect power to the appliance before starting any repair to prevent shock.
• Remove oven racks and any mounting fasteners to access the existing platform.
• Installation typically involves repositioning and fastening the platform with existing screws or clips—keep original hardware unless replacements are specified.
• If the part is heavy or awkward, have a second person assist to avoid injury or damage.