Parts for Kenmore 70062: Recommended Spare Parts

This handheld remote control sends wireless commands to your appliance so you can change settings from a distance. It replaces a lost or non-working remote to restore convenient, button-based control of functions and modes. What it does:

• Sends infrared/wireless signals to the appliance receiver to change settings
• Lets you adjust common functions such as power, mode and temperature/fan settings
• Restores remote operation when the original remote is lost, damaged or unresponsive
• Resolve issues where the appliance doesn't respond to remote commands

• Install fresh batteries before first use and after long storage; use correct battery type
• Point remote at the appliance receiver and test from several feet away; remove obstructions
• If the appliance doesn't respond, check receiver/IR sensor and power to the appliance
• Handle electronic parts carefully; disconnect power to the appliance before servicing internal components

This thermistor is the refrigerator temperature sensor that helps the control board monitor and regulate cooling. Replacing a failed thermistor restores accurate temperature readings for more consistent fridge and freezer performance. What it does:

• Senses internal air temperature and sends that information to the control board
• Helps the defrost and compressor cycles run at the correct times
• Commonly linked to symptoms like inconsistent temperatures, error codes, or a unit that runs constantly
• Does not control cooling directly but provides the temperature feedback the system needs

• Always disconnect power to the appliance before beginning service
• Typically located in the fresh food or freezer compartment near the evaporator
• Handle the sensor and wiring gently; avoid pulling on the wires or bending the probe sharply
• If troubleshooting, verify wiring and sensor resistance per the manufacturer's service instructions before replacement

This compressor start/run capacitor helps the refrigerator compressor get up to speed so the cooling system can run properly. Replaces a worn or failed capacitor to restore reliable compressor starting and stable operation. What it does:

• Provides the brief boost of electrical current the compressor motor needs to start
• Helps maintain consistent motor RPM for steady cooling performance
• Common symptom: compressor hums but won't start or fridge not cooling
• Also used when the compressor cycles frequently or runs hot

• One replacement capacitor

• Disconnect power to the appliance before starting any work
• Discharge the capacitor and use insulated tools to avoid shock
• Note terminal wiring positions or take a photo before removing old part

This replacement platform provides a stable base inside the oven cavity to support the oven floor and related internal components, restoring proper alignment and preventing sagging or rattling. What it does

• Supports the oven floor and internal components to maintain correct alignment.
• Helps stop movement, vibration, or rattling coming from the oven cavity.
• Restores a flat, secure surface for heating elements and cookware.
• Useful when the original platform is bent, warped, or cracked, causing instability.

• One platform.

• Disconnect power to the appliance before starting any repair to prevent shock.
• Remove oven racks and any mounting fasteners to access the existing platform.
• Installation typically involves repositioning and fastening the platform with existing screws or clips—keep original hardware unless replacements are specified.
• If the part is heavy or awkward, have a second person assist to avoid injury or damage.

These printed installation instructions provide the official steps and safety guidance needed when installing the appliance. They help ensure correct setup, proper clearances, and safe operation by following manufacturer-recommended procedures. What it does:

• Lists required mounting steps, clearances, and positioning guidance for proper installation
• Describes connection points and routing for electrical, water, or venting as applicable
• Highlights safety warnings and recommended precautions to reduce risk during install
• Notes any required parts, accessories, or optional components referenced by the manufacturer
• Clarifies sequence of assembly and adjustment steps to achieve correct final fit

• One printed installation instruction manual/sheet as shown

• Read all instructions completely before starting; follow local codes and utility requirements
• Turn off power and water supplies before performing any work
• Retain the instructions with the appliance for future reference and service
• Only perform steps for which you have tools and experience; stop and get help for wiring or gas work