Parts for Frigidaire 5057D: Room Air Conditioner Parts

A round-head wood screw used to secure trim, panels, and small interior components on compatible appliances. Simple replacement that restores proper fastening where the original screw is missing or damaged. What it does:

• Replaces a stripped, missing, or rusted wood screw to restore secure fastening of panels, trim, and mounts.
• Provides a rounded head finish that sits above or countersinks in thin trim pieces.
• Matches the OEM length and thread style for reliable fit in prepared wood or composite mounting points.
• Helps stop rattles, loose panels, and misaligned trim caused by worn or missing fasteners.

• One wood round-head screw (8-15A x 0.750)

• Use the correct-size screwdriver or driver bit to avoid cam-out and head damage.
• Start threading by hand to avoid cross-threading; drive until snug—do not over-tighten.
• If replacing a rusted screw, check surrounding material for damage and replace any compromised anchors.
• Disconnect power to the appliance and follow manufacturer service instructions before servicing.

A replacement flat head slotted screw used to secure interior and exterior appliance panels and components. Keeps covers and brackets fastened so parts stay aligned and operate quietly. What it does:

• Secures panels, trim pieces, brackets and small components
• Restores proper fastening when original screws are missing or stripped
• Helps stop rattling, vibration, or misaligned panels caused by loose hardware

• Use the correct slotted screwdriver sized for 10-12A screws to avoid cam-out
• Hand-start threads to prevent cross-threading; tighten until snug, do not over-torque
• Turn power off and unplug appliance before accessing internal panels
• Retain removed fasteners to confirm correct replacement length and head style

This complete front panel replaces a damaged or worn outer front on compatible Frigidaire appliances, restoring appearance and protecting internal components. It's a direct-fit exterior assembly designed to return the unit's front to factory condition. What it does

• Covers and protects the appliance's front housing and control area from damage and debris.
• Restores a straight, secure mounting surface for doors and trim to improve alignment.
• Fixes symptoms like dents, cracks, bent edges, or cosmetic wear on the appliance front.
• Replaces a warped or misshapen front that causes poor sealing or alignment.

• One complete front panel assembly as shown.

• Disconnect power (and water if applicable) before starting any repair.
• Basic to moderate DIY skill required; door/trim removal and fastener transfer are commonly needed.
• Use only OEM-specified fasteners and follow manufacturer service instructions to avoid damage.