Parts for Ge AKV08FBM1: 01 - Room Air Conditioner Parts

This drive motor replaces the appliance's original motor to restore rotation and normal operation. It provides the mechanical drive force needed for the appliance to spin or move components reliably. What it does:

• Powers the drum/agitator or other moving assemblies so the appliance can run cycles as intended
• Restores normal start and run behavior when a failed motor prevents operation
• Resolves symptoms such as no spin/agitate, intermittent operation, or unusual motor noise
• Transfers torque from the motor to the transmission or belt to enable load movement

• Disconnect power before starting work to avoid electrical shock
• Handle the motor and wiring harness carefully; match connectors and mounting points exactly
• Some models require belt removal, pulley alignment, or access panels to reach the motor

This wire protector is a small plastic protector/insulator that shields appliance wiring at stress points and openings to prevent chafing and shorting. It helps maintain reliable electrical connections and extends the life of the harness. What it does:

• Protects wiring from abrasion where wires pass through metal edges or tight openings
• Helps prevent short circuits caused by exposed conductor wear
• Keeps harness routing neat and reduces strain on terminals
• Supports safe operation by preserving insulation integrity

• One wire protector

• Inspect surrounding wiring and replace any damaged wires or insulation before installing
• Slide protector over the wire or into the opening until seated; avoid forcing or cracking the part
• Disconnect power to the appliance before handling wiring or making repairs

This installation support is a small mounting bracket used to secure your appliance during installation, helping keep trim and components aligned for a stable fit and proper operation. What it does:

• Provides a secure anchor point for mounting trim or enclosure pieces
• Prevents sagging or misalignment of exterior panels after installation
• Helps maintain proper clearance and stable positioning of the appliance
• Designed to work with factory mounting locations for a reliable fit

• One installation support bracket

• Disconnect power and follow the appliance installation instructions before beginning
• Use appropriate hand tools and fasteners per the installation guide; tighten to factory torque if specified
• Check fit and alignment before finalizing trim or panel attachments

This small replacement nut secures appliance components and hardware to keep assemblies stable and operating quietly. It's a simple, direct fix when a loose or missing nut causes rattling or unstable mounting. What it does:

• Secures panels, brackets, or components to prevent movement and vibration
• Restores proper hardware retention when the original nut is stripped, missing, or damaged
• Helps eliminate rattling, loose knobs, or misaligned parts caused by failed fasteners

• Disconnect power and shut off water before servicing the appliance
• Use the correct wrench or socket size and hand-start threads to avoid cross-threading
• Tighten snugly but avoid overtightening, which can strip threads or damage components

This flat metal washer provides a reliable spacer and load distributor for fastening points in the washer assembly, helping maintain proper alignment and secure connections for moving parts. What it does:

• Sits under a nut or bolt to distribute pressure and protect mating surfaces
• Helps maintain proper spacing and alignment of rotating or fastened components
• Can reduce loosening from vibration when used with the correct fastener
• Symptoms of a failed/missing washer: loose fittings, excessive play, noise or intermittent loosening

• One flat metal washer as shown

• Verify correct orientation and placement before torquing the fastener
• Replace any damaged or corroded fasteners along with the washer for best results
• Follow manufacturer torque specs and safety procedures when servicing
• Disconnect power and water and use appropriate tools and PPE