Parts for Ge ASV08FLS1: 01 - Room Air Conditioner Parts

A replacement Blade V assembly that restores the cutting/moving action in select GE appliances. Fits into the original mounting to help reestablish reliable operation and performance when the factory blade is damaged or worn. What it does:

• Replaces a damaged or worn blade to restore proper motion and function
• Helps eliminate symptoms like noisy operation, uneven performance, or reduced effectiveness
• Matches the OEM fit and mounting style for secure, stable operation
• Maintains intended clearance and engagement with mating parts for correct performance

• One Blade V assembly as shown

• Turn off power to the appliance before attempting any service
• Follow the appliance's service manual for disassembly, blade removal, and reassembly steps
• Use appropriate tools and gloves to avoid contact with sharp edges

This door gasket is a flexible replacement seal that restores a tight refrigerator door seal to help keep cold air in and reduce energy loss. Designed to fit OEM specifications for a direct-fit replacement. What it does:

• Creates an airtight seal around the refrigerator door to help maintain consistent internal temperature
• Helps prevent frost buildup and reduces compressor run-time caused by air leaks
• Restores proper door closure for improved food preservation and energy efficiency
• Common symptom: visible gaps, damaged or cracked seal, or cold air leaking from the door

• One replacement door gasket

• Inspect mounting flange and channel for damage or debris before installing; clean surfaces for best seal
• Typical install requires removing the old gasket and seating the new gasket into the door channel; use gentle, even pressure to avoid overstretching
• If gasket is difficult to seat, warming it slightly with a hair dryer on low can improve flexibility (avoid overheating)
• Disconnect power only if required by your specific model's service instructions and follow all safety precautions

This cabinet assembly is the outer housing for the appliance, restoring the oven/microwave exterior and supporting internal components for a secure, finished fit. It replaces damaged or dented cabinets to improve appearance and structural support. What it does:

• Replaces the unit's outer housing to protect internal parts and restore cosmetic appearance
• Provides mounting points and structure for internal components and control assemblies
• Helps reduce air leaks and maintain normal ventilation paths when properly installed
• Commonly replaced for dents, rust, or when the cabinet is bent and doors or panels no longer align

• One cabinet assembly

• Disconnect power (and gas if applicable) before beginning service
• Handle panels carefully to avoid cuts from sharp edges; wear gloves and eye protection
• Installation typically requires removing trim and fasteners and aligning mounting tabs; follow the OEM service manual for correct procedure