Parts for QHM18DXH1: Room Air Conditioner Parts

This UI board cover is the outer trim that protects and finishes the appliance control panel, keeping the user interface and electronics shielded from grease, steam and everyday wear while restoring a clean appearance. What it does:

• Covers and protects the control board and user interface from moisture, dirt and cooking residues
• Provides the finished trim and mounting surface for control buttons and display openings
• Helps prevent accidental contact with electronics behind the control panel
• Replaces cracked, warped or cosmetically damaged control-panel covers

• One UI board cover (single piece)

• Disconnect power to the appliance before starting any repair
• Remove any trim or control-panel screws and lift the old cover away; handle glass or plastic parts carefully to avoid scratches
• Verify orientation and alignment before tightening fasteners; do not force or over-tighten

The Control Board is an OEM component specifically designed for GE window air conditioners. Located internally within the indoor air handling unit, it provides centralized system management and sensor functions. 

The control board regulates critical components like the compressor, condenser fan motor, and temperature-sensing thermistor to enable automatic cool/heat modes. Integrated circuitry safely oversees all operational parameters for dependable temperature control.

Causes of a faulty control board relate to long-term environmental exposure and high-frequency switch operations degrading integrated circuits over many years of duty cycle. 

Symptoms include: 

• Non-responsive or unpredictable temperature settings  
• Error codes displayed or blinking control lights
• Total system failure to power on or operate properly

Replacing with this authentic GE OEM part restores optimized system regulation and trouble-free functionality. Compatible alternatives include select Frigidaire, Westinghouse, or Kenmore AC units.

The Main Circuit Board is an OEM part for GE window air conditioners. It houses the microprocessor and electronic components responsible for regulating all critical functions.  

Symptoms of a faulty main board can include:

• Random operation failures or shutdowns 
• Electrical shorting noises or burning smells 
• Refusal to power on or unresponsive controls
• Inability to maintain set temperatures

Causes typically involve damage from power surges over time or accumulated condensation intrusion into electrical areas. Repeated heat cycling can degrade sensitive onboard semiconductors as well.

This genuine GE replacement restores safe and reliable cooling performance. Compatible with some Frigidaire, Soleus Air, and Honeywell branded units.

This capacitor clamp secures the appliance's start/run capacitor to the frame, keeping the capacitor stable and protected. A snug clamp helps prevent vibration damage and electrical connection issues for reliable motor starting. What it does:

• Holds the capacitor firmly in place to reduce vibration and movement during operation
• Protects capacitor terminals and wiring from rubbing or chafing
• Helps prevent intermittent motor-starting problems caused by a loose capacitor
• Can reduce noise caused by a rattling or unsecured capacitor

• One capacitor clamp/mounting clip as shown

• Always disconnect power to the appliance before accessing electrical components
• If replacing a capacitor as well, discharge the capacitor per OEM instructions before handling
• Inspect surrounding wiring and fasteners; replace any worn clips or damaged insulation
• Secure clamp to the same mounting point and orientation as the original for proper fit

This replacement refrigerator water filter helps reduce taste and odor in drinking water and ice, restoring cleaner-tasting water from your dispenser and ice maker. It's a direct-replacement consumable designed for regular maintenance. What it does

• Removes common taste- and odor-causing chlorine and particulate matter to improve water and ice flavor
• Helps reduce visible particles and cloudiness in dispensed water
• Supports safer-tasting drinking water as part of scheduled filter replacement

• One replacement refrigerator water filter

• Turn off the water supply and dispense water to relieve system pressure before removing the old filter
• Follow the refrigerator manufacturer's instructions for filter removal and insertion to ensure proper seal
• After installation, run several liters of water through the dispenser to flush the new filter and clear air
• Replace per the appliance manufacturer's recommended interval and dispose of used filters properly

This front panel assembly replaces a worn, cracked or damaged control panel trim to restore the appliance's appearance and protect underlying controls. It provides a finished bezel around the control area for a secure, factory look. What it does:

• Covers and protects the control buttons, display and circuit area from spills and debris.
• Restores the appliance's cosmetic appearance when the original panel is scratched, cracked or faded.
• Helps keep control components securely in place and prevents direct contact with internal electronics.
• Commonly replaced when buttons or display edges are exposed, panel is loose, or the fascia is damaged.

• Disconnect power to the appliance before beginning any repair to avoid shock or injury.
• Removal typically requires detaching the outer trim/fascia and may expose sharp edges; wear gloves and eye protection.
• Keep screws and small parts organized during disassembly; some models require control board or trim removal to install the panel.

The Remote Control is an OEM part for GE window air conditioners. It allows convenient wireless operation from across the room.   

Causes of a faulty remote include faded or stuck buttons from heavy usage. Moisture or dust intrusion due to lack of sealing over time can compromise electronics. 

Symptoms of a bad remote control involve:

• Unresponsive or randomly operating buttons  
• Inability to power the unit on or off from a distance
• Range or reception issues where controls don't work
• Missing buttons preventing complete functionality

This GE replacement ensures hassle-free temperature adjustment without approaching the AC unit. Compatible with some Frigidaire, Danby, and Honeywell branded window air conditioners as well. The remote preserves full programming and convenient control when manual overrides are needed at the unit.