Trash Compactor J Base Race Parts

This precision thrust race serves as the hardened bearing surface for axial loads in a rotating mechanism. Replacing a worn race reduces friction and noise, helping restore smooth, consistent motion and protect companion thrust bearings and washers from accelerated wear.

• Provides the hardened bearing surface for a thrust bearing assembly
• Supports axial load and helps maintain proper end-play in the mechanism
• Reduces friction to allow smoother rotation under load
• Wear may present as grinding/scraping noises, rough or binding motion, excessive axial play, or visible scoring

• Disconnect power and shut off water/gas before servicing
• Access the thrust-bearing area; note the order and orientation of races, bearings, and washers for reassembly
• Clean mating surfaces; replace any worn companion parts and lubricate only if specified by the service documentation
• Seat the new race fully and verify free movement by hand before reassembly and testing

The Actuator Switch Kit is an OEM part for Whirlpool trash compactors. This part activates the compaction cycle when the trash compactor's door is shut and locked, ensuring the unit operates safely and effectively. The actuator switch signals the control system to start the compaction process, an essential step in reducing the volume of waste.

Causes of a malfunctioning actuator switch can include prolonged use leading to mechanical wear, electrical failures within the switch itself, or misalignment issues with the compactor's door. 

Symptoms of a bad Actuator Switch Kit include:

• The compactor fails to start the compaction cycle
• The system starts only intermittently or not at all
• Unexpected halting of the compaction process
• The need to manually engage or adjust the switch to start the cycle

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This replacement bucket assembly collects and stores ice produced by the refrigerator ice maker, restoring reliable ice storage and dispensing. Durable plastic construction fits into the freezer ice compartment for easy use and removal. What it does:

• Collects ice produced by the automatic ice maker and holds it for dispensing.
• Helps prevent ice from spilling into the freezer compartment.
• Restores proper alignment for auger or dispenser-fed systems when cracked or broken.
• Commonly used when the ice bucket is cracked, warped, or no longer seats correctly.

• One bucket assembly.

• Disconnect power to the appliance before starting any repair.
• Remove the old bucket by sliding or lifting per the freezer's access design; avoid forcing plastic tabs.
• Handle edges carefully; seat the new bucket fully so any locator tabs or guides engage.
• After installation, restore power and run an ice maker cycle to verify proper operation.

This front panel is the replacement control-panel trim that restores the appliance's appearance and protects the control area from dirt and damage. It gives a clean, finished look and supports the control assembly for reliable operation. What it does:

• Replaces cracked, dented, or scratched front/control-panel trim to restore appearance
• Protects switches, buttons and the control assembly from spills and debris
• Helps hold control components and display in proper alignment for normal use
• Commonly replaced when the panel is warped, has broken mounting tabs, or shows visible cosmetic damage

• Disconnect power to the appliance before starting any repair
• Typical installation uses basic hand tools; support the control assembly while removing fasteners
• Handle painted or coated finishes carefully to avoid scratches during installation
• Reuse any gaskets or clips only if undamaged; replace worn mounting hardware for a secure fit